首页> 美国卫生研究院文献>Polymers >Thiol-Ene Photo-Click Collagen-PEG Hydrogels: Impact of Water-Soluble Photoinitiators on Cell Viability Gelation Kinetics and Rheological Properties
【2h】

Thiol-Ene Photo-Click Collagen-PEG Hydrogels: Impact of Water-Soluble Photoinitiators on Cell Viability Gelation Kinetics and Rheological Properties

机译:硫醇烯光点击胶原蛋白-PEG水凝胶:水溶性光引发剂对细胞活力凝胶动力学和流变性质的影响。

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。

摘要

Thiol-ene photo-click hydrogels were prepared via step-growth polymerisation using thiol-functionalised type-I collagen and 8-arm poly(ethylene glycol) norbornene-terminated (PEG-NB), as a potential injectable regenerative device. Type-I collagen was thiol-functionalised by a ring opening reaction with 2-iminothiolane (2IT), whereby up to 80 Abs. % functionalisation and 90 RPN% triple helical preservation were recorded via 2,4,6-Trinitrobenzenesulfonic acid (TNBS) colorimetric assay and circular dichroism (CD). Type, i.e., either 2-Hydroxy-1-[4-(2-hydroxyethoxy) phenyl]-2-methyl-1-propanone (I2959) or lithium phenyl-2,4,6-trimethylbenzoylphosphinate (LAP), and concentration of photoinitiator were varied to ensure minimal photoinitiator-induced cytotoxicity and to enable thiol-ene network formation of collagen-PEG mixtures. The viability of G292 cells following 24 h culture in photoinitiator-supplemented media was largely affected by the photoinitiator concentration, with I2959-supplemented media observed to induce higher toxic response (0.1 → 0.5% (w/v) I2959, cell survival: 62 → 2 Abs. %) compared to LAP-supplemented media (cell survival: 86 → 8 Abs. %). In line with the in vitro study, selected photoinitiator concentrations were used to prepare thiol-ene photo-click hydrogels. Gelation kinetics proved to be largely affected by the specific photoinitiator, with LAP-containing thiol-ene mixtures leading to significantly reduced complete gelation time (τ: 187 s) with respect to I2959-containing mixtures (τ: 1683 s). Other than the specific photoinitiator, the photoinitiator concentration was key to adjusting the hydrogel storage modulus (G’), whereby 15-fold G’ increase (232 → 3360 Pa) was observed in samples prepared with 0.5% (w/v) compared to 0.1% (w/v) LAP. Further thiol-ene formulations with 0.5% (w/v) LAP and varied content of PEG-NB were tested to prepare photo-click hydrogels with porous architecture, as well as tunable storage modulus (G’: 540–4810 Pa), gelation time (τ: 73–300 s) and swelling ratio (SR: 1530–2840 wt %). The photoinitiator-gelation-cytotoxicity relationships established in this study will be instrumental to the design of orthogonal collagen-based niches for regenerative medicine.
机译:通过硫醇官能化的I型胶原和8臂聚乙二醇降冰片烯封端(PEG-NB)作为潜在的可注射再生装置,通过逐步聚合反应制备硫醇-烯光点击水凝胶。通过与2-亚氨基硫杂环戊烷(2IT)的开环反应,对I型胶原进行硫醇官能化,从而达到80 Abs。通过2,4,6-三硝基苯磺酸(TNBS)比色测定和圆二色性(CD)记录了%官能化和90 RPN%三重螺旋保留。类型,即2-羟基-1- [4-(2-羟基乙氧基)苯基] -2-甲基-1-丙酮(I2959)或苯基-2,4,6-三甲基苯甲酰基次膦酸锂(LAP),以及改变光引发剂以确保最小的光引发剂诱导的细胞毒性,并使胶原-PEG混合物形成硫醇-烯网络。在光引发剂补充的培养基中培养24小时后,G292细胞的活力在很大程度上受光引发剂浓度的影响,观察到I2959补充的培养基诱导更高的毒性反应(0.1→0.5%(w / v)I2959,细胞存活率:62→与补充LAP的培养基(细胞存活率:86→8绝对百分比)相比,降低了2绝对百分比)。与体外研究一致,使用选定的光引发剂浓度来制备硫醇-烯光点击水凝胶。事实证明,胶凝动力学受特定光引发剂的影响很大,相对于含I2959的混合物(τ:1683 s),含LAP的硫醇-烯混合物导致完全胶凝时间(τ:187 s)大大缩短。除了特定的光引发剂,光引发剂的浓度是调节水凝胶储能模量(G')的关键,因此与0.5%(w / v)相比,制备的样品中G'增加了15倍(232→3360 Pa)。 0.1%(w / v)LAP。测试了具有0.5%(w / v)LAP和不同含量的PEG-NB的其他硫醇-烯制剂,以制备具有多孔结构以及可调节的储能模量(G':540–4810 Pa)的光点击水凝胶,凝胶化时间(τ:73–300 s)和溶胀率(SR:1530–2840 wt%)。在这项研究中建立的光引发剂-胶凝作用-细胞毒性关系将有助于设计用于再生医学的正交胶原基壁ni。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
代理获取

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号