...
首页> 外文期刊>Journal of Food Science and Technology >Quality of ready-to-eat komal chawal produced by brown rice parboiling method
【24h】

Quality of ready-to-eat komal chawal produced by brown rice parboiling method

机译:用糙米帕尔布林制作的即食komal小鳖的质量

获取原文
获取原文并翻译 | 示例
           

摘要

Komal chawal, meaning soft rice, produced by brown rice parboiling of a low amylose rice variety chokuwa, was studied for its physical, physico-chemical, morphological and structural characteristics. The product was produced by soaking the brown rice at 60 degrees C for 90min, followed by steaming and air drying to 12.0% (wb). The two steaming conditions used were: (1) open-steaming at atmospheric pressure for 20min and (2) pressure-steaming at 1atm (gauge) for 10min. The three different drying temperatures used were 40, 50 and 60 degrees C. When soaked in water at 60 degrees C for 20min the product attained a hardness value of cooked rice. The extent of changes in the kernel and flour properties as compared to the raw form were affected by the severity of the steaming condition and drying air temperature. The pressure steamed samples exhibited virtually persistent growth in paste viscosity in the profiles obtained from the rapid viscosity analyzer. X-ray diffraction analysis of flours revealed a loss of A-type pattern and formation of feeble peaks of A+V-type mixed patterns in steam-treated samples. Scanning electron photomicrographs showed the loss of the polygonal shape by starch granules during processing. The values of rehydration ratio, equilibrium moisture content for rehydration, sediment volume, extent of color change as denoted by total color difference, and the percent head rice yield were higher in pressure steamed komal chawal samples.
机译:基于褐色稻瘟病生产的软米饭的Komal Chawal,研究了低淀粉酱油稻瘟病,其物理化学,物理化学,形态学和结构特征。通过将糙米浸泡在60℃下浸泡90分钟,然后蒸汽和空气干燥至12.0%(WB)制备产物。所使用的两个蒸汽条件是:(1)在大气压下开放蒸汽20分钟和(2)1ATM(仪表)的压力蒸汽10分钟。使用的三种不同的干燥温度为40,50和60℃。当在60℃下浸泡在水中20min时,该产品达到熟米的硬度值。与原始形式相比,核和面粉性能的变化程度受到蒸汽条件的严重程度和干燥空气温度的影响。压力蒸蒸质样品在从快速粘度分析仪获得的曲线中表现出几乎持续的糊状生长。面粉的X射线衍射分析显示出蒸汽处理样品中+ v型混合图案的α型图案的损失和形成的虚弱峰。扫描电子显微照片显示在加工过程中通过淀粉颗粒丢失多边形形状。再水化率的再水化率,沉积物体积平衡水分含量,颜色变化程度,如全色差异的表示,压力蒸氯瘤除去百分比产量较高。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号