Low-Power All-Digital Multiphase DLL Design Using a Scalable Phase-to-Digital Converter

摘要

This work presents a low-power all-digital approach to multiphase delay locked loop (DLL) design by the use of a scalable phase-to-digital converter (PDC) based on asynchronous sampling. The PDC is used as a linear phase detector (PD) with the ability to measure any phase difference leading to a shorter delay line with less power consumption. Two different approaches for the delay cell implementation are investigated. The digitally controlled shunt-capacitor inverter (SCI) delay cell leads to an extremely small design with the delay line being the only analog component, while the voltage controlled current-starved inverter (CSI) delay cell has a lower power consumption and less jitter. The proposed design procedure of the SCI based DLL allows fast simulation using Verilog based models since no analog low pass filter is required. Using the proposed modeling technique for the PDC, the behavior of the DLL can be estimated based on input clock jitter specifications. The SCI and CSI based multiphase DLL designs are fabricated in a 65nm CMOS process operated from a 1.2V supply. The proposed SCI based DLL occupies only 0.0048 mm(2) of active area and consumes 2.25mW at 2.5GHz input frequency with a 622.6MHz sample clock. The RMS jitter of the circuit is 1.2 ps and 1.4 ps for the DLL loop and the phase shifter loop, respectively. The RMS jitter is significantly reduced with the CSI based DLL to 0.86 ps and the power consumption of 2.64mW at 4GHz input frequency with a 996.1MHz sample clock provides an improved power efficiency compared to the SCI based DLL. As a trade-off, the area is increased to 0.0085 mm(2) due to the use of a Delta Sigma modulator and an analog low pass filter.