首页> 外文期刊>IEEE Transactions on Electron Devices >2-D–3-D Switchable Gate Driver Circuit for TFT-LCD Applications
【24h】

2-D–3-D Switchable Gate Driver Circuit for TFT-LCD Applications

机译:TFT-LCD应用的2-D–3-D可切换栅极驱动器电路

获取原文
获取原文并翻译 | 示例

摘要

This paper presents a novel 2-D–3-D switchable gate driver circuit for active-matrix liquid crystal displays (AMLCDs) applications using the hydrogenated amorphous silicon (a-Si:H) technology. While consisting of 12 thin-film transistors (TFTs), the proposed gate driver circuit includes a pull-up circuit, two alternative circuits, and a key pull-down circuit. To provide a stable output waveform for switching between the 2-D and 3-D modes in AMLCD panel, the proposed circuit can improve the threshold voltage shift of a-Si:H TFT using reversed bias stress. Based on a real circuit integrated on glass with a standard five-mask process applied to a large-sized FHD TFT-LCD panel, the layout area of each gate driver circuit is 359.25 $mu{rm m}times,$ 2296.25 $mu{rm m}$ . In addition, the power consumption of a 12-stage gate driver circuit is 3.25 and 7.21 mW, while operating at 2-D and 3-D modes, respectively. Measurement results indicate that the output waveform, including output voltage, rising time, and falling time can be stabilized and made almost equal to the initial state after the reliability test at 100 $^{circ}{rm C}$ over 240 h.
机译:本文介绍了一种使用氢化非晶硅(a-Si:H)技术的有源矩阵液晶显示器(AMLCD)应用的新型2-D–3-D可切换栅极驱动器电路。所建议的栅极驱动器电路虽然由12个薄膜晶体管(TFT)组成,但它包括一个上拉电路,两个备用电路和一个按键下拉电路。为了在AMLCD面板中的2-D和3-D模式之间切换提供稳定的输出波形,该电路可以使用反向偏置应力改善a-Si:H TFT的阈值电压漂移。基于在玻璃上集成的真实电路,并在大型FHD TFT-LCD面板上应用标准的五掩模工艺,每个栅极驱动器电路的布局面积为359.25 $ mu {rm m}倍,$ 2296.25 $ mu { rm m} $。此外,当以2-D和3-D模式工作时,12级栅极驱动器电路的功耗分别为3.25和7.21 mW。测量结果表明,经过100小时的可靠性测试,在240小时内,包括输出电压,上升时间和下降时间在内的输出波形可以稳定并几乎等于初始状态。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号