Design and evaluation of a bolted joint for a discrete carbon-epoxy rod-reinforced hat section

摘要

The use of prefabricated pultruded carbon-epoxy rods has reduced the manufacturing complexity and costs of stiffened composite panels while increasing the damage tolerance of the panels. However, repairability of these highly efficient discrete stiffeners has been a concern. Design, analysis, and test results are presented in this paper for a bolted-joint repair for the pultruded rod concept that is capable of efficiently transferring axial loads in a hat-section stiffener on the upper skin segment of a heavily loaded aircraft wing component. A tension and a compression joint design were evaluated. The tension joint design achieved approximately 1.0 strain in the carbon-epoxy rod-reinforced hat-section and failed in a metal fitting at 166 of the design ultimate load. The compression joint design failed in the carbon-epoxy rod-reinforced hat-section test specimen area at approximately 0.7 strain and at 110 of the design ultimate load. This strain level of 0.7 in compression is similar to the failure strain observed in previously reported carbon-epoxy rod-reinforced hat-section column tests.