首页> 外文期刊>Radiation measurements >Dependence of thermoluminescence in LiF : Mg,Cu,Na,Si phosphor on Na dopant concentration and thermal treatment
【24h】

Dependence of thermoluminescence in LiF : Mg,Cu,Na,Si phosphor on Na dopant concentration and thermal treatment

机译:LiF中的热致发光:Mg,Cu,Na,Si荧光粉对Na掺杂剂浓度和热处理的依赖性

获取原文
获取原文并翻译 | 示例

摘要

A new phosphor, LiF:Mg,Cu,Na,Si, has been developed in this laboratory for thermoluminescence. The thermoluminescence dependence on the concentration of Na dopant between 0 mol% and 0.45 mol% and thermal treatment between 240degreesC and 310degreesC was investigated. With an increase of Na concentration, the TL sensitivity and the main peak increase when the annealing temperature is less than 300degreesC. With an increase of annealing temperature, the position of the main glow peak shifts markedly towards higher temperatures, irrespective of Na concentrations. The height of the main peak depends strongly on the annealing temperature. TL sensitivity remains stable at annealing temperatures from 260degreesC to 300degreesC for 0 mol% Na concentration, from 250degreesC to 300degreesC for 0.05 mol% Na concentration, from 260degreesC to 290degreesC for 0.1 mol% Na concentration, from 260degreesC to 280degreesC for 0.2 mol% Na concentration, from 250degreesC to 270degreesC for 0.35 mol% Na concentration, or from 2600,C to 280degreesC for 0.45 mol% Na concentration. The ratio of the intensity annealed at 310degreesC to the intensity annealed at 260degreesC seems to be reduced with an increase of Na concentration. Thermal susceptibility of LiF:Mg,Cu,Na,Si appears to be associated with the Na concentration. The lower the Na concentration, the less sensitive the TL is to annealing temperature. The optimum Na dopant concentration was found to be 0%. (C) 2003 Elsevier Science Ltd. All rights reserved. [References: 15]
机译:该实验室已开发出一种新型的荧光粉LiF:Mg,Cu,Na,Si用于热致发光。研究了Na掺杂剂的浓度在0mol%至0.45mol%之间以及在240℃至310℃之间的热处理对热致发光的依赖性。随着Na浓度的增加,当退火温度低于300℃时,TL灵敏度和主峰增加。随着退火温度的升高,无论Na浓度如何,主辉光峰的位置都会明显移向更高的温度。主峰的高度很大程度上取决于退火温度。 TL灵敏度在0 mol%Na浓度下从260摄氏度到300摄氏度,在0.05 mol%Na浓度下从250摄氏度到300摄氏度,在0.1 mol%Na浓度下从260摄氏度到290摄氏度,在0.2 mol%Na浓度下从260摄氏度到280摄氏度保持稳定。 Na浓度为0.35 mol%时,从250摄氏度到270摄氏度; Na浓度为0.45 mol%时,从2600,C到280摄氏度。随着Na浓度的增加,在310℃下退火的强度与在260℃下退火的强度之比似乎降低。 LiF:Mg,Cu,Na,Si的热敏性似乎与Na浓度有关。 Na浓度越低,TL对退火温度的敏感性越低。发现Na掺杂剂的最佳浓度为0%。 (C)2003 Elsevier ScienceLtd。保留所有权利。 [参考:15]

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号