...
首页> 外文期刊>Current applied physics: the official journal of the Korean Physical Society >Effects of substrates on structural and optical properties of Cu-poor CuGaSe_2 thin films prepared by in-situ co-evaporation
【24h】

Effects of substrates on structural and optical properties of Cu-poor CuGaSe_2 thin films prepared by in-situ co-evaporation

机译:衬底对原位共蒸发制备贫铜CuGaSe_2薄膜的结构和光学性能的影响

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

We investigated the structural and optical properties of Cu-poor CuGaSe_2 (CGSe) films depending on the use of different substrates: indium-doped tin oxide (ITO) coated soda-lime glass (SLG) and fluorine-doped tin oxide (FTO) coated SLG as back contacts, widely used Mo-coated SLG, and pure SLG. The Cu-poor phase is chosen as a counterpart of Cu-poor Cu(In,Ga)Se _2 to show the highest efficiency in this class of materials, and also give a test board for parasitic phases which might influence on device properties. Although the Cu-poor CGSe thin-films were deposited on the four substrates at the same time in an identical condition, they showed differences in the morphology and grain size due to different CGSe/substrate interfaces and growth mechanisms depending on the substrates. These surface properties of the CGSe films were identified clearly by atomic force microscopy (AFM) measurements. X-ray diffraction (XRD) measurement also supported the result of the AFM analysis and showed that the preferred orientation of CGSe is (112), independent of the substrates. The existence of parasitic phases was examined by Raman and photoluminescence spectroscopic techniques. While defect compounds such as CuGa_3Se_5 and CuGa_5Se_8 were identified for all films, the signals related to these parasitic phases are strongest for the films on the pure SLG substrate. Furthermore, the absorption property was investigated by spectroscopic ellipsometry in a photon energy range of 0.7-5 eV. We found that the absorption coefficient values for the CGSe films are about 10~4-10~5 cm~(-1) in the visible region. The absorption coefficient is also changed according to the use of different substrates. This difference comes from the parasitic phase formation, which leads to an increase of the bandgap and suppression of the optical absorption strength. Our systematic study suggests clearly that the difference in distribution of parasitic phases in the CGSe films could originate primarily from the different substrates used for the film deposition.
机译:我们根据不同基板的使用情况研究了贫铜CuGaSe_2(CGSe)膜的结构和光学性能:铟掺杂的氧化锡(ITO)涂层的钠钙玻璃(SLG)和氟掺杂的氧化锡(FTO)涂层SLG作为背触点,广泛使用Mo涂层SLG和纯SLG。选择贫铜相作为贫铜(In,Ga)Se _2的对应物,以显示此类材料中的最高效率,并且还给出了可能影响器件性能的寄生相测试板。尽管贫铜CGSe薄膜以相同的条件同时沉积在四个基板上,但由于不同的CGSe /基板界面和生长机理(取决于基板),它们在形态和晶粒尺寸上均表现出差异。 CGSe膜的这些表面性质通过原子力显微镜(AFM)测量清楚地确定。 X射线衍射(XRD)测量也支持AFM分析的结果,并表明CGSe的优选取向为(112),与基材无关。通过拉曼光谱和光致发光光谱技术检查了寄生相的存在。虽然已为所有膜识别出诸如CuGa_3Se_5和CuGa_5Se_8之类的缺陷化合物,但与这些寄生相有关的信号对于纯SLG基板上的膜而言最强。此外,通过光谱椭圆偏振法在0.7-5eV的光子能量范围内研究了吸收性质。我们发现CGSe薄膜在可见光区的吸收系数约为10〜4-10〜5 cm〜(-1)。吸收系数也根据不同基板的使用而改变。该差异来自寄生相的形成,这导致带隙的增加和光吸收强度的抑制。我们的系统研究清楚地表明,CGSe薄膜中寄生相分布的差异可能主要源于用于薄膜沉积的不同衬底。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号