...
首页> 外文期刊>ACS applied materials & interfaces >Influence of Chemical Composition and Structure in Silicon Dielectric Materials on Passivation of Thin Crystalline Silicon on Glass
【24h】

Influence of Chemical Composition and Structure in Silicon Dielectric Materials on Passivation of Thin Crystalline Silicon on Glass

机译:硅介电材料的化学组成和结构对玻璃上薄晶硅钝化的影响

获取原文
获取原文并翻译 | 示例
           

摘要

In this study, various silicon dielectric films, namely, a-SiOx:H, a-SiNx:H, and a-SiOxNy:H, grown by plasma enhanced chemical vapor deposition (PECVD) were evaluated for use as interlayers (ILs) between crystalline silicon and glass. Chemical bonding analysis using Fourier transform infrared spectroscopy showed that high values of oxidant gases (CO2 and/or N-2), added to SiH4 during PECVD, reduced the Si H and N H bond density in the silicon dielectrics. Various three layer stacks combining the silicon dielectric materials were designed to minimize optical losses between silicon and glass in rear side contacted hetero junction pn test cells. The PECVD grown silicon dielectrics retained their functionality despite being subjected to harsh subsequent processing such as crystallization of the silicon at 1414 degrees C or above. High values of short circuit current density (j; without additional hydrogen passivation) required a high density of Si H bonds and for the nitrogen containing films, additionally, a high N H bond density. Concurrently high values of both J and open circuit voltage Voc were only observed when [Si- H] was equal to or exceeded [N-H]. Generally, V with a high density of [Si I-] bonds in the silicon dielectric; otherwise, additional hydrogen passivation using an active plasma process was required. The highest V., 560 mV, for a silicon acceptor concentration of about 1016 cm(-3), was observed for stacks where an a-SiOx.Ny:H film was adjacent to the silicon. Regardless of the cell absorber thickness, field effect passivation of the buried silicon surface by the silicon dielectric was mandatory for efficient collection of carriers generated from short wavelength light (in the vicinity of the glass Si interface). However, additional hydrogen passivation was obligatory for an increased diffusion length of the photogenerated carriers and thus j in solar cells with thicker absorbers.
机译:在这项研究中,评估了通过等离子增强化学气相沉积(PECVD)生长的各种硅介电膜,即a-SiOx:H,a-SiNx:H和a-SiOxNy:H,用作它们之间的中间层(IL)晶体硅和玻璃。使用傅里叶变换红外光谱的化学键合分析表明,在PECVD期间添加到SiH4中的高价氧化剂气体(CO2和/或N-2)降低了硅电介质中的Si H和N H键密度。设计了各种结合了硅介电材料的三层堆叠,以使背面接触的异质结pn测试单元中的硅和玻璃之间的光学损失最小化。尽管经历了苛刻的后续处理(例如,在1414摄氏度或更高的温度下硅的结晶化),PECVD生长的硅电介质仍保留了其功能。高的短路电流密度值(j;无需额外的氢钝化)需要高的Si H键密度,而对于含氮薄膜,则还需要高的N H键密度。仅当[Si-H]等于或超过[N-H]时,才观察到J和开路电压Voc的高值。通常,在硅电介质中具有[Si I-]键的高密度的V。否则,需要使用有源等离子体工艺进行额外的氢钝化。对于a-SiOx.Ny:H薄膜与硅相邻的叠层,对于约1016 cm(-3)的硅受体浓度,可观察到最高的560 mV。不管电池吸收层的厚度如何,对于有效收集由短波长光(在玻璃Si界面附近)产生的载流子,必须通过硅电介质对掩埋的硅表面进行场效应钝化。但是,必须增加氢钝化才能增加光生载流子的扩散长度,从而在吸收层较厚的太阳能电池中增加j。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号