首页> 外文期刊>Plasma Science, IEEE Transactions on >Characteristics and Diffusion of Electrical Explosion Plasma of Aluminum Wire in Argon Gas
【24h】

Characteristics and Diffusion of Electrical Explosion Plasma of Aluminum Wire in Argon Gas

机译:氩气中铝丝电爆炸等离子体的特性和扩散

获取原文
获取原文并翻译 | 示例

摘要

Electrical explosion of aluminum wire is a very promising method for aluminum nanoparticle production. The exploding wire plasma has significant influence on the formation of the nanoparticles. In this paper, the electron temperatures and the electron densities in the plasma are estimated through Boltzmann plot and Stark broadening effect. The aluminum particle densities, charge state distributions, and the energy relaxation in the plasma are estimated accordingly. The diffusion of the plasma into protective argon gas is studied through its spatial distribution. The electron temperatures of the electrical explosion of wire (EEW) plasma with an aluminum wire in argon gas are 1~2 eV, and the electron densities are of the order of magnitude ~1019/cm3, which decrease rapidly over time after the EEW occurs. The diffusion of the EEW plasma of aluminum wire into ambient argon gas can be divided into two main phases, namely, the previous fast diffusion phase and the subsequent slow diffusion phase. The plasma is with quite different diffusion features due to the differences of the corresponding relative number density of the plasma to argon gas. For plasma with relative density much higher than 1, the diffusion velocity in the fast diffusion phase is significantly higher than that with relative density near 1, and in the slow diffusion phase, the distribution radius of the plasma can continue to increase significantly due to the considerable energy coupled from the circuit to the aluminum particles. Dependence of the plasma radii on the deposited energies are derived from the experimental data. For plasma with relative density near 1, due to the much longer relaxation time during the slow diffusion phase, very little energy can be transferred from the circuit to the aluminum particles and the plasma radii only increase slightly during this phase after the aluminum particles spent most of their kinetic energy in the previous fast diffusion phase.
机译:铝线的电爆炸是生产铝纳米粒子的非常有前途的方法。爆炸丝等离子体对纳米颗粒的形成具有重大影响。本文通过玻尔兹曼图和斯塔克展宽效应估算等离子体中的电子温度和电子密度。相应地估计了铝颗粒的密度,电荷态分布和等离子体中的能量弛豫。通过其空间分布研究了等离子体向保护性氩气中的扩散。氩气中的铝丝焊丝(EEW)等离子体与铝丝发生电爆炸的电子温度为1〜2 eV,电子密度为〜1019 / cm3量级,在EEW发生后,电子密度随时间迅速降低。铝线的EEW等离子体向周围氩气中的扩散可分为两个主要阶段,即先前的快速扩散阶段和随后的缓慢扩散阶段。由于等离子体相对于氩气的相对数量密度的差异,等离子体具有非常不同的扩散特征。对于相对密度远高于1的等离子体,快速扩散相中的扩散速度显着高于相对密度接近1的等离子体,而在慢速扩散相中,由于扩散,等离子体的分布半径可以继续显着增加。从电路耦合到铝颗粒的能量很大。从实验数据得出等离子体半径对沉积能量的依赖性。对于相对密度接近1的等离子体,由于在缓慢扩散阶段的弛豫时间更长,因此几乎没有能量从电路转移到铝颗粒,并且在此阶段,在铝颗粒消耗最多之后,等离子体半径仅略有增加在前一个快速扩散阶段的动能。

著录项

  • 来源
    《Plasma Science, IEEE Transactions on》 |2017年第2期|185-192|共8页
  • 作者单位

    State Key Laboratory of Electrical Insulation and Power Equipment, and the High Voltage Division, School of Electrical Engineering, Xi’an Jiaotong University, Xi’an, China;

    School of Electronics and Information Engineering, Xi’an Jiao Tong University, Xi’an, China;

    Beijing Electric Power Economic Research Institute, Beijing, China;

    State Key Laboratory of Electrical Insulation and Power Equipment, and the High Voltage Division, School of Electrical Engineering, Xi’an Jiaotong University, Xi’an, China;

    State Key Laboratory of Electrical Insulation and Power Equipment, and the High Voltage Division, School of Electrical Engineering, Xi’an Jiaotong University, Xi’an, China;

  • 收录信息 美国《科学引文索引》(SCI);美国《工程索引》(EI);
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

    Wires; Aluminum; Plasma temperature; Argon; Explosions;

    机译:电线;铝;等离子温度;氩气;爆炸;

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号