...
首页> 外文期刊>Neurocomputing >Motion planning and adaptive neural sliding mode tracking control for positioning of uncertain planar underactuated manipulator
【24h】

Motion planning and adaptive neural sliding mode tracking control for positioning of uncertain planar underactuated manipulator

机译:不确定平面欠驱动机械手定位的运动规划和自适应神经滑模跟踪控制

获取原文
获取原文并翻译 | 示例
           

摘要

The research on the robust control of uncertain planar underactuated manipulators is almost nonexistent due to the lack of actuator and the uncontrollability at equilibrium points. Taking an uncertain planar three-link passive-active-active underactuated manipulator as an example, this paper develops a robust control scheme including motion planning and adaptive tracking control to realize its position control. According to the constraints between the passive link and active links and the target position of the manipulator, differential evolution algorithm is used to solve the target angles and ratio between the angular velocities. Then, a set of motion trajectories is planned based on the target values. Considering the uncertain parameter perturbation and external disturbance exist, we use RBF neural network to online approximate the uncertainty. Meanwhile, we develop a set of fast terminal sliding mode controllers to track the planned trajectories, and design adaptive laws to guarantee the stability and convergence of the tracking system. Next, an online iteration algorithm is presented to correct the deviations of all link angles caused by the parameter perturbation, which makes the manipulator gradually approach to its target position. Finally, the simulation results verify the effectiveness of the proposed method. (C) 2019 Elsevier B.V. All rights reserved.
机译:由于缺乏致动器和平衡点的不可控性,对不确定平面欠驱动机械手的鲁棒控制的研究几乎不存在。以一个不确定的平面三连杆被动-主动-主动欠驱动机械手为例,提出了一种鲁棒的控制方案,包括运动规划和自适应跟踪控制,以实现其位置控制。根据被动连杆与主动连杆之间的约束以及机械手的目标位置,采用差分演化算法求解目标角度和角速度之比。然后,基于目标值计划一组运动轨迹。考虑到不确定性参数的摄动和外部干扰的存在,我们使用RBF神经网络在线近似不确定性。同时,我们开发了一套快速终端滑模控制器来跟踪计划的轨迹,并设计自适应律以保证跟踪系统的稳定性和收敛性。接下来,提出了一种在线迭代算法来校正由参数摄动引起的所有连杆角度的偏差,这使得机械手逐渐接近其目标位置。最后,仿真结果验证了该方法的有效性。 (C)2019 Elsevier B.V.保留所有权利。

著录项

  • 来源
    《Neurocomputing》 |2019年第21期|197-205|共9页
  • 作者单位

    China Univ Geosci, Sch Automat, Wuhan 430074, Hubei, Peoples R China|Hubei Key Lab Adv Control & Intelligent Automat C, Wuhan 430074, Hubei, Peoples R China|Concordia Univ, Dept Mech Ind & Aerosp Engn, Montreal, PQ H3G 1M8, Canada;

    China Univ Geosci, Sch Automat, Wuhan 430074, Hubei, Peoples R China|Hubei Key Lab Adv Control & Intelligent Automat C, Wuhan 430074, Hubei, Peoples R China;

    China Univ Geosci, Sch Automat, Wuhan 430074, Hubei, Peoples R China|Hubei Key Lab Adv Control & Intelligent Automat C, Wuhan 430074, Hubei, Peoples R China;

    China Univ Geosci, Sch Automat, Wuhan 430074, Hubei, Peoples R China|Hubei Key Lab Adv Control & Intelligent Automat C, Wuhan 430074, Hubei, Peoples R China;

  • 收录信息 美国《科学引文索引》(SCI);美国《工程索引》(EI);
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

    Planar underactuated manipulator; Robust control; Motion planning and tracking; RBF neural network; Adaptive terminal sliding mode control; Differential evolution algorithm;

    机译:平面欠驱动机械手;鲁棒控制;运动计划与跟踪;RBF神经网络;自适应终端滑模控制;差分进化算法;

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号