首页> 外文期刊>IEEE transactions on circuits and systems . I , Regular papers >A Cascaded Mode-Switching Sub-Sampling PLL With Quadrature Dual-Mode Voltage Waveform-Shaping Oscillator
【24h】

A Cascaded Mode-Switching Sub-Sampling PLL With Quadrature Dual-Mode Voltage Waveform-Shaping Oscillator

机译:具有正交双模电压波形整形振荡器的级联模式切换子采样PLL

获取原文
获取原文并翻译 | 示例

摘要

A cascaded mode-switching sub-sampling PLL with quadrature dual-mode voltage waveform-shaping oscillator is proposed in this paper. The dual-mode voltage waveform-shaping oscillator is introduced to extend the tuning range and improve phase noise performance at mm-wave frequency, simultaneously. Meanwhile, the dual-mode quadrature topology is investigated to reduce the phase noise and quadrature phase error, compared to conventional quadrature oscillator. Then, the proposed oscillator is applied in a cascaded PLL with divider-less mode-switching sub-sampling loop, which can obtain the merits of high frequency-resolution, low loop noise, and wide frequency locking range. Both the dual-mode voltage waveform-shaping oscillator and the cascaded PLL are verified and fabricated in a 28-nm CMOS process. The FoM and FoMT of the oscillator at 10 MHz offset are -188.2 dBc/Hz and -200.7 dBc/Hz respectively. The proposed PLL prototype exhibits a frequency range from 22.8 to 33.9 GHz with a typical power consumption of 41.7 mW. The phase noise across the frequency band is from -104.1 to -108.2 dBc/Hz at 1 MHz offset. The jitter FoMj is -236.2 dB.
机译:本文提出了一种具有正交双模电压波形整形振荡器的级联模式切换子采样PLL。引入双模电压波形整形振荡器以延长调谐范围,并同时提高MM波频率的相位噪声性能。同时,与传统的正交振荡器相比,研究了双模正态拓扑以降低相位噪声和正交相位误差。然后,所提出的振荡器用级联的PLL施加在级联的PLL中,其分隔的模式切换子采样环路,其可以获得高频分辨率,低回路噪声和宽频锁定范围的优点。双模电压波形整形振荡器和级联PLL都经过验证和级联PLL,并在28nm CMOS工艺中制造。振荡器的FOM和FOMT分别为10 MHz偏移量-188.2 dBc / Hz和-200.7 dBc / Hz。所提出的PLL原型展示频率范围为22.8至33.9GHz,典型功耗为41.7兆瓦。频带上的相位噪声位于-104.1至-108.2 dBc / hz,在1 MHz偏移量。抖动FOMJ为-236.2 dB。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号