首页> 外文期刊>Surface review and letters >Photoelectrical properties of p-type and n-type electrical conductivity amorphous carbon thin films for application in economical carbon-based solar cells
【24h】

Photoelectrical properties of p-type and n-type electrical conductivity amorphous carbon thin films for application in economical carbon-based solar cells

机译:用于经济型碳基太阳能电池的p型和n型电导率非晶碳薄膜的光电性能

获取原文
获取原文并翻译 | 示例
           

摘要

The successful deposition of boron (B)-doped p-type (p-C:B) and phosphorous (P)-doped n-type (n-C:P) carbon (C) films, and fabrication of p-C:B on silicon (Si) substrate (p-C:B-Si) and n-C:P/p-Si cells by the technique of pulsed laser deposition (PLD) using graphite target is reported. The cells' performances are represented in the dark I-V rectifying curve and I-V 2 working curve under illumination when exposed to AM 1.5 illumination condition (100 mW/cm(2), 25 degrees C). The open circuit voltage (V-oc) and short circuit current density (J(sc)) for p-C:B-Si are observed to vary from 230-250 mV and 1.5-2.2 mA/cm(2), respectively, and to vary from 215-265 mV and 7.5-10.5 mA/cm(2), respectively, for n-C:P/p-Si cells. The p-C:B-Si cell fabricated using the target with the amount of B by 3 Bwt% shows highest energy conversion efficiency, eta = 0.20%, and fill factor, FF = 45%, while, the n-C:P/p-Si cell with the amount of P by 7 Pwt% shows highest energy conversion efficiency, eta = 1.14%, and fill factor, FF = 41%. The quantum efficiencies (QE) of the p-C:B-Si and n-C:P/p-Si cells are observed to improve with Bwt% and Pwt%, respectively. The contributions of QE are suggested to be due to photon absorption by carbon layer in the lower wavelength region (below 750 nm) and Si substrates in the higher wavelength region. The dependence of B and P content on the electrical and optical properties of the deposited films, and the photovoltaic characteristics of the respective p-C:B-Si and n-C:P/ p-Si heterojunction photovoltaic cells, are discussed.
机译:掺杂硼(B)的p型(pC:B)和掺杂磷(P)的n型(nC:P)碳(C)膜的成功沉积,以及在硅(Si)上制备pC:B的过程报道了通过使用石墨靶的脉冲激光沉积(PLD)技术的基板(pC:B / n-Si)和nC:P / p-Si电池。当暴露于AM 1.5照明条件(100 mW / cm(2),25摄氏度)下,在光照条件下的暗I-V整流曲线和I-V 2工作曲线表示电池的性能。观察到pC:B / n-Si的开路电压(V-oc)和短路电流密度(J(sc))分别在230-250 mV和1.5-2.2 mA / cm(2)之间变化,对于nC:P / p-Si电池,其变化范围分别为215-265 mV和7.5-10.5 mA / cm(2)。使用B含量为3 Bwt%的靶材制造的pC:B / n-Si电池显示出最高的能量转换效率eta = 0.20%和填充系数FF = 45%,而nC:P / p P含量为7 Pwt%的-Si电池显示出最高的能量转换效率eta = 1.14%,填充因子FF = 41%。观察到p-C:B / n-Si和n-C:P / p-Si电池的量子效率(QE)分别随Bwt%和Pwt%的提高而提高。认为QE的贡献是由于较低波长区域(低于750 nm)中的碳层和较高波长区域中的Si衬底对光子的吸收。讨论了B和P含量对沉积膜的电学和光学性质的依赖性,以及相应的p-C:B / n-Si和n-C:P / p-Si异质结光伏电池的光伏特性。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号