首页> 外文期刊>Optics and Spectroscopy >Studying the Energy Dependence of Intrinsic Conversion Efficiency of Single Crystal Scintillators Under X-ray Excitation
【24h】

Studying the Energy Dependence of Intrinsic Conversion Efficiency of Single Crystal Scintillators Under X-ray Excitation

机译:X射线激发下单晶闪烁体本征转换效率的能量依赖性研究

获取原文
获取原文并翻译 | 示例
           

摘要

Single crystal scintilators are used in various radiation detectors applications. The efficiency of the crystal can be determined by the Detector Optical Gain (DOG) defined as the ratio of the emitted optical photon flux over the incident radiation photons flux. A parameter affecting DOG is the intrinsic conversion efficiency (n_C) giving the percentage of the X-ray photon power converted to optical photon power. n_C is considered a constant value for X-ray energies in the order of keV although a non-proportional behavior has been reported. In this work an analytical model, has been utilized to single crystals scintillators GSO:Ce, LSO:Ce and LYSO:Ce to examine whether the intrinsic conversion efficiency shows non proportional behavior under X-ray excitation. DOG was theoretically calculated as a function of the incident X-ray spectrum, the X-ray absorption efficiency, the energy of the produced optical photons and the light transmission efficiency. The theoretical DOG values were compared with experimental data obtained by irradiating the crystals with X-rays at tube voltages from 50 to 140 kV and by measuring the light energy flux emitted from the irradiated screen. An initial value for n_C (calculated from literature data) was assumed for the X-ray tube voltage of 50 kV. For higher X-ray tube voltages the optical photon propagation phenomena was assumed constant and any deviations between experimental and theoretical data were associated with changes in the intrinsic conversion efficiency. The experimental errors were below 7% for each experimental setup. The behavior of n_C values for LSO:Ce and LYSO:Ce were found very similar, i.e., ranging with values from 0.089 at 50 kV to 0.015 at 140 kV, while for GSO:Ce, n_C demonstrated a peak at 80 kV.
机译:单晶闪烁器用于各种辐射探测器应用中。晶体的效率可以通过探测器光学增益(DOG)来确定,探测器光学增益定义为发射的光子通量与入射辐射光子通量之比。影响DOG的参数是固有转换效率(n_C),它给出了X射线光子功率转换为光子光子功率的百分比。尽管已报告了非比例行为,但n_C被认为是keV量级的X射线能量常数。在这项工作中,分析模型已用于单晶闪烁体GSO:Ce,LSO:Ce和LYSO:Ce,以检查固有转换效率在X射线激发下是否显示出不成比例的行为。理论上计算DOG为入射X射线光谱,X射线吸收效率,产生的光子的能量和光传输效率的函数。将理论DOG值与通过以50至140 kV的管电压用X射线照射晶体并测量从照射的屏幕发出的光能通量获得的实验数据进行比较。对于50 kV的X射线管电压,假定n_C的初始值(根据文献数据计算)。对于更高的X射线管电压,假定光子传播现象是恒定的,并且实验数据和理论数据之间的任何偏差都与本征转换效率的变化有关。每种实验设置的实验误差均低于7%。发现LSO:Ce和LYSO:Ce的n_C值的行为非常相似,即范围从50 kV时的0.089到140 kV时的0.015,而对于GSO:Ce,n_C的峰值在80 kV时表现出峰值。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号