【24h】

Luminescence studies in thermal oxide films with Si implantation

机译:硅注入热氧化膜的发光研究

获取原文
获取原文并翻译 | 示例
           

摘要

The objective of this work is to investigate the origin of the emission bands of Photo and Cathodo - luminescence (PL, CL) in thermal silicon dioxide films implanted with Silicon. The films were obtained by 150 KeV Si implantation into thermal oxide, with doses of 1 x 10(16) cm(-2) and 1 x 10(17) cm(-2). Thermal treatments of 0, 30, 60 and 180 minutes in nitrogen at 1100 degreesC were applied. We found light emission in the visible range, the bands change with the ion implantation conditions and thermal treatments. The as implanted samples present photoluminescence bands around 1.95 eV and 2.4 eV for both doses, and they disappear with thermal treatments. After annealing, the low dose samples has a photoluminescence band at 2.6 eT while those of dose of 1 x 10(17) cm(-2) has a bond centered at 1.7 eV The intensity of the bands changes with thermal treatment The cathodoluminescence bands are at 2.7 eV for both implantation doses in samples with and without thermal treatments. A discussion of the results and conclusions that contribute to better understand this nowadays controversial subject is presented. [References: 10]
机译:这项工作的目的是研究注入硅的热二氧化硅薄膜中光和阴极发光(PL,CL)的发射带的起源。该膜是通过将150 KeV Si注入热氧化物中而获得的,剂量分别为1 x 10(16)cm(-2)和1 x 10(17)cm(-2)。在氮气中于1100℃进行0、30、60和180分钟的热处理。我们发现光发射在可见光范围内,能带随离子注入条件和热处理而变化。两种剂量的植入样品均呈现1.95 eV和2.4 eV左右的光致发光带,并且在热处理后它们消失了。退火后,低剂量样品在2.6 eT处有一个光致发光带,而剂量为1 x 10(17)cm(-2)的样品具有一个以1.7 eV为中心的键。带的强度随热处理而变化。在有和没有热处理的情况下,两种注入剂量的电导率均为2.7 eV。讨论了有助于更好地理解当今有争议主题的结果和结论。 [参考:10]

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号