...
首页> 外文期刊>Wear: an International Journal on the Science and Technology of Friction, Lubrication and Wear >Effects of beta-Si3N4 whiskers addition on mechanical properties and tribological behaviors of Al matrix composites
【24h】

Effects of beta-Si3N4 whiskers addition on mechanical properties and tribological behaviors of Al matrix composites

机译:β-Si3N4晶须添加对Al基复合材料的机械性能和摩擦学行为的影响

获取原文
获取原文并翻译 | 示例

摘要

beta-Si3N4 whiskers reinforced Al matrix composites were prepared by hot pressing. The effect of beta-Si3N4 whiskers addition on the microstructure, mechanical properties and tribological behaviors of composites were investigated. The dry sliding wear test was conducted with a sliding speed of 0.5 m/s, at different applied load of 10, 20 and 40 N, respectively. The Vickers hardness, ultimate compression strength (UCS) and the wear resistance of Al matrix were enhanced significantly with the addition of whiskers. As the increase in whisker content, there was a clear transfer of wear mechanism from the combination of serious delamination wear and abrasive wear to the mild abrasive wear at the 20 N applied load condition. The composites reinforced with 15 vol% whiskers exhibited the best wear resistance under higher applied load. The mechanically mixed layer (MML) formed during sliding had a protective effect on the worn surface. Higher mechanical properties of composites and lower applied load helped to keep the MML stable. The slighter the wear degree of composites is, the lower the coefficient of friction is.
机译:通过热压制备增强Al基质复合材料的β-Si3N4晶须。研究了β-Si3N4晶须的作用,对复合材料的微观结构,机械性能和摩擦学行为进行了添加。干燥滑动磨损试验以0.5m / s的滑动速度进行,分别在10,20和40n的不同施加载荷。随着晶须显着提高了维氏硬度,极限压缩强度(UCS)和Al基质的耐磨性。随着晶须内容的增加,从20N施加的负载条件下的严重分层磨损和磨料磨损的组合,磨损机构的结合透明转移。用15体积%的晶须加强的复合材料在较高施加的载荷下表现出最佳耐磨性。在滑动期间形成的机械混合层(MML)对磨损表面具有保护作用。复合材料的较高机械性能和较低施加的负荷有助于保持MML稳定。复合材料的磨损程度越小,摩擦系数越低。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号