...
首页> 外文期刊>Journal of Nuclear Materials: Materials Aspects of Fission and Fusion >Application of pulsed laser irradiation for removal of hydrogen retained in tungsten
【24h】

Application of pulsed laser irradiation for removal of hydrogen retained in tungsten

机译:脉冲激光照射在去除钨中残留氢中的应用

获取原文
获取原文并翻译 | 示例
           

摘要

For the purpose of removal of tritium retained in tungsten (W), pulsed laser irradiation has been applied. The laser light used here was the fourth harmonic of Nd: YAG laser (wavelength; 266 nm, pulse width; 20 ps, pulse frequency; 10 Hz, laser energy up to 3 mJ/pulse). Samples were pure W plates and those saturated with D by D2+ ion implantation at room temperature with using a 2.5 keV ion gun. Released ions and molecules by the laser irradiation were measured by a time-of-flight mass spectrometer (TOFMS) and a quadrupole mass spectrometer (Q-mass), respectively. Ablation of W was observed by the laser irradiation with a deposited power density above 1.5 × 10~(11) W/cm~2 (3 J/cm~2/pulse) (an ablation threshold) and D removals below and above the ablation threshold were quite different. The most effective removal of tritium retained in W could be realized by the pulsed laser irradiation with the power density of just below the ablation threshold.
机译:为了去除钨(W)中残留的tri,已应用脉冲激光辐照。此处使用的激光是Nd:YAG激光的第四谐波(波长; 266 nm,脉冲宽度; 20 ps,脉冲频率; 10 Hz,激光能量高达3 mJ /脉冲)。样品是纯W板,在室温下使用2.5 keV离子枪通过D2 +离子注入使样品充满D。通过飞行时间质谱仪(TOFMS)和四极质谱仪(Q-mass)分别测量激光照射释放的离子和分子。通过激光辐照观察到W的烧蚀,沉积功率密度高于1.5×10〜(11)W / cm〜2(3 J / cm〜2 /脉冲)(烧蚀阈值),D去除在烧蚀之上和之下门槛大不相同。可以通过功率密度刚好低于烧蚀阈值的脉冲激光辐照来实现去除钨中残留的most的最有效方法。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号