首页> 外文期刊>Carbohydrate research >SOME FACTORS DETERMINING THE THERMAL PROPERTIES OF AMYLOSE INCLUSION COMPLEXES WITH FATTY ACIDS
【24h】

SOME FACTORS DETERMINING THE THERMAL PROPERTIES OF AMYLOSE INCLUSION COMPLEXES WITH FATTY ACIDS

机译:确定直链淀粉包合物和脂肪酸的热性质的一些因素

获取原文
获取原文并翻译 | 示例
           

摘要

The thermal properties of water-insoluble amylose-stearic acid (18:0) complexes prepared under various conditions were studied by differential scanning calorimetry (DSC). Complexes were studied normally at a concentration of 5% in water at pH similar to 7. Type I complexes formed at less than or equal to 60 degrees C had dissociation temperatures (T-m) in the range 96-104 degrees C. Type IIa polymorphs formed at greater than or equal to 90 degrees C had T-m = 114-121 degrees C. Various ratios of types I and IIa were formed at 80 degrees C depending on the duration of heating, but no intermediate form was detected. Annealing of the type IIa complex at 105 degrees C and at 115 degrees C gave rise to increasing proportions of type IIb polymorphs with T-m = 121-125 degrees C and dissociation enthalpies of 32-34 J/g of amylose, depending on the temperature and time of annealing. Conversion into the higher polymorphs was retarded at a higher concentration (10%) of the complex under identical conditions, and was delayed at pH similar to 4.7. The dissociation temperatures of amylose complexes with the cis-unsaturated fatty acids oleic (18:1), linoleic (18:2), and linolenic (18:3) also depended on the temperature of formation, and three distinct types were obtained (I, IIa, and IIb). Significant decreases in the T-m of the three polymorphs were observed for each double bond in the fatty acid guest molecule. When type I and type II complexes were made using various proportions of 18:0 and 18:2, mixed acid complexes were obtained with T-m values intermediate between those of the monoacid complexes. The origin of the endothermic transitions on heating the three types of complexes is discussed. [References: 54]
机译:通过差示扫描量热法(DSC)研究了在各种条件下制备的水不溶性直链淀粉-硬脂酸(18:0)配合物的热性能。通常在pH值类似于7的水中以5%的浓度研究复合物。在小于或等于60摄氏度的条件下形成的I型配合物的解离温度(Tm)在96-104摄氏度范围内。在大于或等于90℃的温度下,Tm = 114-121℃。取决于加热的持续时间,在80℃下形成各种比例的I和IIa型,但未检测到中间形式。 IIa型复合物在105摄氏度和115摄氏度下的退火导致IIb型多晶型物的比例增加,Tm = 121-125摄氏度,解离焓为32-34 J / g直链淀粉,具体取决于温度和退火时间。在相同条件下,在较高浓度(10%)的配合物下,转化为较高的多晶型物的速度受到抑制,而在类似于4.7的pH值下,则转化速度变慢。直链淀粉复合物与顺式不饱和脂肪酸油酸(18:1),亚油酸(18:2)和亚麻酸(18:3)的解离温度也取决于形成温度,并获得了三种不同的类型(I ,IIa和IIb)。对于脂肪酸客体分子中的每个双键,观察到三个多晶型物的T-m显着降低。当使用各种比例的18:0和18:2制备I型和II型配合物时,获得的混合酸配合物的T-m值介于单酸配合物的中间。讨论了加热三种类型的配合物时吸热转变的起源。 [参考:54]

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号