...
首页> 外文期刊>Polymer engineering and science >Study on High-Performance Poly(etheretherketone)/Si3N4 Nanocomposites: New Electronic Substrate Materials
【24h】

Study on High-Performance Poly(etheretherketone)/Si3N4 Nanocomposites: New Electronic Substrate Materials

机译:高性能聚醚醚酮/ Si3N4纳米复合材料的研究:新型电子基板材料

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

The morphology, thermal, mechanical, and dielectric properties of high-performance poly(etheretherketone)/ Si3N4 nanocomposites fabricated by hot pressing were investigated. It was found that the coefficient of thermal expansion (CTE) and dissipation factor decreased significantly with increasing Si3N4 content, whereas thermal stability was affected slightly. A nanocompo-site with 30 wt% Si3N4 exhibited about 45% and 23% decrease in CTE, below and above T_g, respectively. The glass-transition temperature (T_g) was increased up to 20 C. Microhardness was improved by 20% at 10 wt% Si3N4 content and thereafter it improved slightly. Modified rule of mixture with β = 0.1 or Halpin-Tsai model with ζ = 4 fits well the microhardness. The dielectric constant and loss factor of the nanocomposites are quite low, and thermal stability is much higher compared with commercial products. Various models were also used to correlate CTE and dielectric constant.
机译:研究了通过热压制备的高性能聚(醚醚酮)/ Si3N4纳米复合材料的形貌,热学,机械和介电性能。发现随着Si3N4含量的增加,热膨胀系数(CTE)和耗散因数显着降低,而热稳定性受到的影响很小。具有30wt%的Si 3 N 4的纳米复合位点在T_g以下和以上分别显示出约45%和23%的CTE降低。将玻璃化转变温度(T_g)提高至20℃。在Si 3 N 4含量为10重量%时,显微硬度提高了20%,此后略有提高。 β= 0.1的混合物或ζ= 4的Halpin-Tsai模型的修正规则非常适合显微硬度。与商业产品相比,纳米复合材料的介电常数和损耗因子非常低,并且热稳定性更高。还使用了各种模型来关联CTE和介电常数。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号