首页> 外文期刊>IEEE Transactions on Microwave Theory and Techniques >High-Frequency Noise Characterization and Modeling of SiGe HBTs
【24h】

High-Frequency Noise Characterization and Modeling of SiGe HBTs

机译:SiGe HBT的高频噪声表征和建模

获取原文
获取原文并翻译 | 示例

摘要

For heterojunction bipolar transistors (HBTs), the noise correlation influences the noise parameters and is therefore relevant for transistor modeling, especially at sufficiently high frequencies. In order to predict the noise correlation, it is necessary to determine the noise transit time in the noise transport model. In this paper, the noise correlation and noise transit time are predicted from the high current model without measured noise data. The four noise parameters are calculated based on the predicted noise transit time and the Y-parameter noise calculation methodology. The extracted noise transit time is validated by the measured result over bias and temperature, which is determined by fitting NFmin of the silicon-germanium (SiGe) HBT between Y-parameter noise calculation methodology and tuner-based noise measurement. It was found that the noise transit time is independent of frequency but dependent on bias and temperature. Also, the results indicate that the calculated four noise parameters based on the extracted noise transit time have a good agreement with the tuner-based noise measurement.
机译:对于异质结双极晶体管(HBT),噪声相关性会影响噪声参数,因此与晶体管建模有关,尤其是在足够高的频率下。为了预测噪声相关性,有必要确定噪声传输模型中的噪声传播时间。本文中,在没有测量噪声数据的情况下,根据大电流模型预测了噪声相关性和噪声传播时间。根据预测的噪声传播时间和Y参数噪声计算方法,计算四个噪声参数。提取的噪声传播时间通过在偏置和温度范围内的测量结果验证,该结果是通过在Y参数噪声计算方法和基于调谐器的噪声测量之间拟合硅锗(SiGe)HBT的NFmin来确定的。发现噪声传播时间与频率无关,但与偏置和温度有关。此外,结果表明,基于提取的噪声传播时间计算出的四个噪声参数与基于调谐器的噪声测量结果具有良好的一致性。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号