首页> 外文期刊>IEEE transactions on circuits and systems . I , Regular papers >A Multiphase-Output Delay-Locked Loop With a Novel Start-Controlled Phase/Frequency Detector
【24h】

A Multiphase-Output Delay-Locked Loop With a Novel Start-Controlled Phase/Frequency Detector

机译:具有新型启动控制相/频检测器的多相输出延迟锁定环

获取原文
获取原文并翻译 | 示例

摘要

This paper presents a multiphase-output delay-locked loop (MODLL). The proposed phase/frequency detector (PFD) utilizes a new NAND-resettable dynamic D-flip-flop (DFF) circuit to achieve a shorter reset path. Thus, lower power consumption and higher speed can be obtained. The proposed voltage-controlled delay element used in this design can operate at a lower supply voltage and overcome the dead-band issue of the voltage-controlled delay line. An experimental multiphase-output DLL was designed and fabricated using a TSMC 0.35-$mu$m 2P4M CMOS process. The delay-locked loop (DLL) power consumption is 3.4 mW with a 2 V supply and a 100 MHz input. The measured rms and peak-to-peak jitters are 17.575 ps and 145 ps, respectively. In addition, the supply voltage of the experimental multiphase-output DLL can vary from 1.5 V to 2.5 V without causing malfunctions. The active area is 426 $mu$m $times$ 381 $mu$m.
机译:本文提出了一种多相输出延迟锁定环(MODLL)。提出的相位/频率检测器(PFD)利用新型NAND可复位动态D触发器(DFF)电路来实现更短的复位路径。因此,可以获得较低的功耗和较高的速度。在本设计中使用的建议电压控制延迟元件可以在较低的电源电压下工作,并克服了电压控制延迟线的死区问题。使用台积电0.35-μm2P4M CMOS工艺设计和制造了实验性多相输出DLL。使用2 V电源和100 MHz输入时,延迟锁定环路(DLL)功耗为3.4 mW。测得的均方根值和峰峰值抖动分别为17.575 ps和145 ps。此外,实验性多相输出DLL的电源电压可以在1.5 V至2.5 V之间变化,而不会引起故障。活动区域是426 $ mu $ m $ times $ 381 $ mu $ m。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号