首页> 外文期刊>Analog Integrated Circuits and Signal Processing >New design of 3.2–4.8 GHz generator for multi-bands architecture of UWB communication
【24h】

New design of 3.2–4.8 GHz generator for multi-bands architecture of UWB communication

机译:用于UWB通信的多频段体系结构的3.2–4.8 GHz发生器的新设计

获取原文
获取原文并翻译 | 示例

摘要

In this paper a new design of Ultra-Wide Band (UWB) generator is presented. This circuit is the most important block in multi-bands transmitter architecture of UWB communication system. The proposed UWB generator is composed of multi-bands voltage controlled oscillator (VCO), mixer and rectangular pulse generator which consist of ring oscillator, time delay and AND gate function. The UWB generator is based on multiplying the rectangular pulse envelope to a continuous sinusoidal wave in order to generate the UWB signal. This UWB generator circuit produces an output signal which is characterized by the bandwidth of 1600 MHz divided into three sub-bands of 528 MHz, centered at frequencies of 3.432, 3.96, 4.488 GHz and the limited Power Spectral Density (PSD) is −41.44 dBm/MHz. The maximum amplitude of UWB signal is 214 mV, the pulse is during of 3 ns and the pulse repetition period (PRP) is 32 ns. The power consumption is approximately equal to 26 mW at a voltage supply of 2.5 V. This topology is designed in CMOS 0.35 μm AMS process technology.
机译:本文提出了一种新的超宽带(UWB)发生器设计。该电路是UWB通信系统多频段发射机架构中最重要的模块。拟议的UWB发生器由多频带压控振荡器(VCO),混频器和矩形脉冲发生器组成,后者由环形振荡器,延时和与门功能组成。 UWB发生器基于将矩形脉冲包络乘以连续的正弦波以生成UWB信号。此UWB发生器电路产生的输出信号的特征是1600 MHz的带宽分为528 MHz的三个子带,分别以3.432、3.96、4.488 GHz的频率为中心,而受限的功率谱密度(PSD)为−41.44 dBm / MHz。 UWB信号的最大幅度为214 mV,脉冲为3 ns,脉冲重复周期(PRP)为32 ns。在2.5 V的电源电压下,功耗大约等于26 mW。此拓扑是采用CMOS 0.35μmAMS处理技术设计的。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号