首页> 美国卫生研究院文献>Science and Technology of Advanced Materials >Miniaturized planar Si-nanowire micro-thermoelectric generator using exuded thermal field for power generation
【2h】

Miniaturized planar Si-nanowire micro-thermoelectric generator using exuded thermal field for power generation

机译:利用渗出的热场发电的小型平面硅纳米线微热电发电机

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。

摘要

For harvesting energy from waste heat, the power generation densities and fabrication costs of thermoelectric generators (TEGs) are considered more important than their conversion efficiency because waste heat energy is essentially obtained free of charge. In this study, we propose a miniaturized planar Si-nanowire micro-thermoelectric generator (SiNW-μTEG) architecture, which could be simply fabricated using the complementary metal–oxide–semiconductor–compatible process. Compared with the conventional nanowire μTEGs, this SiNW-μTEG features the use of an exuded thermal field for power generation. Thus, there is no need to etch away the substrate to form suspended SiNWs, which leads to a low fabrication cost and well-protected SiNWs. We experimentally demonstrate that the power generation density of the SiNW-μTEGs was enhanced by four orders of magnitude when the SiNWs were shortened from 280 to 8 μm. Furthermore, we reduced the parasitic thermal resistance, which becomes significant in the shortened SiNW-μTEGs, by optimizing the fabrication process of AlN films as a thermally conductive layer. As a result, the power generation density of the SiNW-μTEGs was enhanced by an order of magnitude for reactive sputtering as compared to non-reactive sputtering process. A power density of 27.9 nW/cm2 has been achieved. By measuring the thermal conductivities of the two AlN films, we found that the reduction in the parasitic thermal resistance was caused by an increase in the thermal conductivity of the AlN film and a decrease in the thermal boundary resistance.
机译:为了从废热中收集能量,热电发电机(TEG)的发电密度和制造成本比其转换效率更为重要,因为废热能基本上是免费获得的。在这项研究中,我们提出了一种微型平面Si-纳米线微热电发生器(SiNW-μTEG)架构,可以使用互补的金属-氧化物-半导体兼容工艺简单制造。与传统的纳米线μTEG相比,该SiNW-μTEG具有利用渗出的热场发电的特性。因此,不需要蚀刻掉衬底以形成悬浮的SiNW,这导致较低的制造成本和得到良好保护的SiNW。我们实验证明,当SiNWs从280减少到8μm时,SiNW-μTEG的发电密度提高了四个数量级。此外,我们通过优化AlN薄膜作为导热层的制造工艺,降低了寄生热阻,这在缩短的SiNW-μTEG中变得尤为重要。结果,与非反应性溅射工艺相比,用于反应性溅射的SiNW-μTEG的发电密度提高了一个数量级。功率密度达到27.9 nW / cm 2 。通过测量两个AlN薄膜的热导率,我们发现寄生热阻的降低是由AlN薄膜的热导率增加和热边界电阻的降低引起的。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
代理获取

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号