首页> 外文会议>Fifteenth International Symposium on Chemical Vapor Deposition, May 14-18, 2000, Toronto, Ontario >KINETIC AND MECHANISTIC STUDIES OF THE CHEMICAL VAPOR DEPOSITION OF Ti-Si-N THIN FILMS WITH Ti(NMe_2)_4 (TDMAT), NH_3, and SiH_4
【24h】

KINETIC AND MECHANISTIC STUDIES OF THE CHEMICAL VAPOR DEPOSITION OF Ti-Si-N THIN FILMS WITH Ti(NMe_2)_4 (TDMAT), NH_3, and SiH_4

机译:Ti(NMe_2)_4(TDMAT),NH_3和SiH_4的Ti-Si-N薄膜化学气相沉积的动力学和机理研究

获取原文
获取原文并翻译 | 示例

摘要

Various aspects of the kinetics and mechanism occurring during the thermal chemical vapor deposition of Ti-Si-N thin films using Ti(NMe_2)_4, tetrakis(dimethylamido)titanium (TDMAT), silane, and ammonia have been determined by molecular beam mass spectrometry coupled to a CVD reactor. Silane is activated in the presence of TDMAT and ammonia at 723 K. Additionally, multiple silane molecules are activated by each TDMAT molecule. The kinetics of the TDMAT decomposition (in the absence of silane and ammonia) were measured between 300 and 500 K. The rate constants for TDMAT decay increase with reactor surface-to-volume (S/V) ratio, particularly above 500 K. The Arrhenius plots for the TDMAT decay in these studies indictae a change in mechanism at higher temperatures. For S/V ratio = 0.118 mm~(-1), the Arrhenius parameters between 300 and 500 K are: E_a = 16 +- 2 kjJmol and A = 32 +-4 sec~(-1). For the high temperature regime above 500 K, E_a = 166 +- 16 kJ/mol and A = 1.6 (+- 0.2) x 10~(16) sec~(-1). These parameters are consistent with the following mechanistic interpretation for TDMAT decay: activated adsorption to the walls at low temperatures, followed by gas phase unimolecular decomposition in combination with some surface process at higher temperatures.
机译:已经通过分子束质谱法确定了使用Ti(NMe_2)_4,四(二甲基氨基)钛(TDMAT),硅烷和氨气在Ti-Si-N薄膜的热化学气相沉积过程中发生的动力学和机理的各个方面耦合到CVD反应器。硅烷在TDMAT和氨气存在下于723 K活化。另外,每个TDMAT分子活化多个硅烷分子。在300至500 K之间测量了TDMAT分解的动力学(在没有硅烷和氨的情况下).TDMAT衰减的速率常数随反应器表面积/体积比(S / V)的增加而增加,特别是在500 K以上时。在这些研究中,TDMAT衰减的阿累尼乌斯图指示了高温下机理的变化。对于S / V比= 0.118 mm〜(-1),介于300和500 K之间的Arrhenius参数为:E_a = 16 + -2 kjJmol和A = 32 + -4 sec〜(-1)。对于高于500 K的高温状态,E_a = 166±16 kJ / mol,A = 1.6(±0.2)x 10〜(16)sec〜(-1)。这些参数与以下针对TDMAT衰减的机理解释是一致的:在低温下活化吸附到壁上,然后在较高温度下气相单分子分解并结合某些表面过程。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号