Numerical simulation studies of mass transfer under steady and unsteady fluid flow in two- and three-dimensional spacer-filled channels

摘要

Hollow fibre and spiral wound membrane (SWM) modules are the most common commercially available membrane modules. The latter dominate especially for RO, NF and UF and are the focus of this study. The main difficulty these types of modules face is concentration polarisation. In SWM modules, the spacer meshes that keep the membrane leaves apart also help reduce the effects of concentration polarisation. The spacer filaments act as flow obstructions, and thus encourage flow destabilisation and increase mass transfer enhancement. One of the detrimental aspects of the use of spacers is an increase of pressure losses in SWM modules. This study analyses the mechanisms that give rise to mass transfer enhancement in narrow spacer-filled channels, and investigates the relationship between flow destabilisation, energy losses and mass transfer. It shows that the regions of high mass transfer on the membrane surface correlate mainly with those regions where the fluid flow is towards the membrane. Based on the insights gained from this analysis, a series of multi-layer spacer designs are proposed and evaluated. In this thesis, a Computational Fluid Dynamics (CFD) model was used to simulate steady and unsteady flows with mass transfer in two- and three-dimensional narrow channels containing spacers. A solute with a Schmidt number of 600 dissolving from the wall and channel Reynolds numbers up to 1683 were considered. A fully-developed concentration profile boundary condition was utilised in order to reduce the computational costs of the simulations. Time averaging and Fourier analysis were performed to gain insight into the dynamics of the different flow regimes encountered, ranging from steady flow to vortex shedding behind the spacer filaments. The relationships between 3D flow effects, vortical flow, pressure drop and mass transfer enhancement were explored. Greater mass transfer enhancement was found for the 3D geometries modelled, when compared with 2D geometries, due to wall shear perpendicular to the bulk flow and streamwise vortices. Form drag was identified as the main component of energy loss for the flow conditions analysed. Implications for the design of improved spacer meshes, such as extra layers of spacer filaments to direct the bulk flow towards the membrane walls, and filament profiles to reduce form drag are discussed.