The cross wedge rolling process is commonly used for the manufacturing of shaft or for preforms, being used for preliminary operation of forming cycle. The presence of angular deformation produced during the rolling process is analyzed in this paper. This work shows some experimental results obtained on parts made of steel in semi-industrial condition. Visioplasticity technique is used to measure the angular displacement occurring in some sections with reference to the adjacent ones. Thus the test samples are prepared to include surface grooves filled up with quite similar steel grade. After rolling process, angular deformations are highlighted by observations and external deformation profile. Influence of surface texture of the forming area is experimentally demonstrated. Moreover, the numerical simulation with the software FORGE is used to verify the adequacy between the observed phenomena and forecasts which can be obtained today.Conclusions about the relative influence of friction factors on the internal stresses creation are finally presented to better identify potential occurrence of these phenomena. Strain diagrams are used to bring out the magnitude of angular variations depending on local plastic strain on parts. Possible consequences for process optimization are raised.
展开▼
