Design Rules for MR Fluid Actuators in Different Working Modes

摘要

The behaviour of actuators based on magnetorheological fluids is determined by a variety of pararneters the magnetorheological properties of the MR suspension, the working mode (shear mode, flow mode, squeeze mode) and the design of the magnetic circuit consisting of MR fluid, flux guide and coil all considerably influence the properties of the actuator. This paper presents design rules for MR fluid actuators in different working modes. The behaviour of MR fluids in the three working modes was investigated by using a rotational viscometer, a flow mode damper and a new measuring technique working in the squeeze mode. The measurement results for various magnetic flux densities are reported and the results of the different working modes are compared. High dynamic damping forces dependent on the magnetic field can be achieved especially in the squeeze mode . The design of the magnetic circuit of an MK fluid actuator is analysed by using finite-element-methods. The advantages of integrating permanent magnets into the magnetic circuit of an MR fluid actuator are pointed out. The working point of the actuator can be adjusted by permanent magnets without consuming any power and the maximum power required to drive the actuator can be reduced. From these results design rules for MR fluid actuators are developed.