Minimizing 1/f Noise in Magnetic Sensors with a MEMS Flux Concentrator

摘要

New approaches offer the promise of providing energy efficient, low cost, small, and highly sensitive magnetic sensors. However, the 1/f noise of these new types of sensors is a major obstacle. Many army applications, such as detecting moving targets, require sensitivity at low frequencies. This paper reports development of a device, the MEMS flux concentrator, invented at ARL, that minimizes the effect of 1/f noise in sensors. The device accomplishes this by shifting the operating frequency to higher frequencies where 1/f noise is much lower. This shift is accomplished by modulating the magnetic field before it reaches the sensor. In our device, the magnetic sensor, a GMR sensor, is placed between flux concentrators that have been deposited on MEMS flaps. The motion of the MEMS flaps modulates the field by a factor of 3 at frequencies from 8 to 15 kHz. The MEMS flux concentrator should increase the sensitivity of many magnetic sensors by two to three orders of magnitude. An equally important benefit is that, because it is a modulation technique, it eliminates the problem of dealing with the large DC bias of most magnetoresistive sensors.