Phase behaviour of SMA/PMMA blends: The influence of processing at low and high deformation rates

摘要

The influence of processing parameters (deformations) on SMA/PMMA blend phase behaviour is studied. It is found that injection moulding does change polymer blend phase behaviour. Phase separation kinetics are important to understand the injection moulding experiments and the kinetics are probably influenced by the deformations caused by the injection moulding proces, Capillary flow causes a complex change of polymer blend phase behaviour showing both deformation induced mixing and redemixing. Short capillaries, causing almost only uniaxial elongation in combination with pressure, cause no change to polymer blend phase behaviour. This is probably due to the short time the deformation is imposed to the material: it is expected that elongation is a main parameter causing changes in polymer blend phase behaviour. Parallel plate rheometer experiments show that applying only shear causes a complex change of phase behaviour showing both shear induced mixing and redemixing. [References: 8]