...
首页> 外文期刊>Applied Spectroscopy: Society for Applied Spectroscopy >Spatially Multiplexed Imaging: Fluorescence Correlation Spectroscopy for Efficient Measurement of Molecular Diffusion at Solid-Liquid Interfaces
【24h】

Spatially Multiplexed Imaging: Fluorescence Correlation Spectroscopy for Efficient Measurement of Molecular Diffusion at Solid-Liquid Interfaces

机译:空间多路复用成像:荧光相关光谱法在固液界面上有效测量分子扩散

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

Fluorescence correlation spectroscopy (FCS) has become an important technique for the characterization of molecular dynamics, especially at interfaces. Fluorescence correlation spectroscopy provides both temporal and spatial resolution for measuring fast processes at equilibrium through analysis of noise in fluorescence intensities from the statistical fluctuations in a small number of molecules. The small molecular populations produce very low-level fluorescence signals, where time-averaging the fluorescence autocorrelation function is needed to generate reasonable signal-to-noise (S/N) ratios. Recently imaging cameras have been adapted to FCS measurements of molecular dynamics at interfaces (membranes and surfaces) through the use of electron-multiplying charge-coupled device (EM-CCD) detectors for acquisition of fluorescence from addressable areas on the detector. This approach provides a major advantage over traditional focused-spot FCS by allowing electronic control over the location and area of the acquired region on the sample surface. Imaging-FCS can also provide a spatial multiplexing advantage through its ability to measure intensity data from larger areas in parallel with no loss of time resolution. In this work, this multiplexing advantage is exploited to determine molecular diffusion rates from the simultaneous measurement of multiple areas on a surface, the autocorrelation traces from which are averaged to improve the S/N ratio. As proof of concept, the diffusion of 1,1'-dioctadecyl-3,3,3'3'-tetramethylindocarbocyanine perchlorate (DiI) on a C-18-modified interface was measured using this multiplexed method and compared to autocorrelation data acquired from a single spot. Due to the slow thermal recovery of the EM-CCD that inhibits fast time-averaging, spatial multiplexing in imaging-FCS provides an eightyfold time savings to reach the same S/N ratio as multiple (time-averaged) measurements from a single spot.
机译:荧光相关光谱法(FCS)已成为表征分子动力学尤其是界面动力学的重要技术。荧光相关光谱学提供了时间和空间分辨率,可通过分析少量分子的统计波动引起的荧光强度噪声来测量平衡时的快速过程。小分子种群产生非常低水平的荧光信号,需要时间平均的荧光自相关函数来产生合理的信噪比(S / N)。最近,通过使用电子倍增电荷耦合器件(EM-CCD)检测器从检测器上可寻址区域获取荧光,成像相机已适应于界面(膜和表面)分子动力学的FCS测量。通过允许对样品表面上采集区域的位置和面积进行电子控制,该方法相对于传统的聚焦点FCS具有主要优势。成像-FCS还可以通过并行测量较大区域的强度数据而不会损失时间分辨率,从而提供空间复用优势。在这项工作中,利用这种多路复用优势,可以通过同时测量表面上的多个区域来确定分子扩散速率,对这些区域的自相关迹线进行平均以提高信噪比。作为概念验证,使用此复用方法测量了在C-18修饰的界面上1,1'-二十八烷基-3,3,3'3'-四甲基吲哚基花青高氯酸盐(DiI)的扩散,并将其与自一个点。由于EM-CCD的缓慢热恢复抑制了快速的时间平均,因此成像FCS中的空间复用可节省八倍的时间,以达到与从单个点进行多次(时间平均)测量相同的S / N比。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号