首页> 外文期刊>Anthropologischer Anzeiger >Sex estimation using the femur of Austrians born in the 19th to the middle of the 20th century
【24h】

Sex estimation using the femur of Austrians born in the 19th to the middle of the 20th century

机译:使用19世纪至20世纪中叶出生的奥地利人的股骨进行性别估算

获取原文
获取原文并翻译 | 示例
           

摘要

Sex estimation of human bones or bone fragments is crucial for the identification process of unknown bodies. Regional differences and secular changes lead to ever changing osteometric standards for different populations. This study provides femoral dimensions of Austrians born between 1822 and 1949 and evaluates the discriminating power of sex estimation functions developed by discriminant analyses. Depending on the state of preservation up to 127 femora of adult individuals (72 females and 55 males) were measured. The following means and standard variations were obtained: Maximum length (male: 449.7 +/- 16.7 mm, female: 413.9 +/- 16.3 mm), head circumference (148.5 +/- 7.8 vs. 133.8 +/- 6.4 mm), vertical (46.9 +/- 2.4 vs. 41.9 +/- 2.1 mm), transverse (46.3 +/- 2.4 vs. 41.5 +/- 2.0 mm), and maximum head diameter (47.0 +/- 2.3 vs. 42.0 +/- 2.1 mm), as well as sagiftal (28.3 +/- 2.2 vs. 26.2 +/- 1.8 mm), transverse (27.9 +/- 2.5 vs. 26.1 +/- 2.0 mm), and maximum midshaft diameter (29.2 +/- 2.1 vs. 27.3 +/- 1.6 mm) and finally condylar width (79.6 +/- 4.6 vs. 71.9 +/- 3.8 mm). The (cross-validated) discriminant analysis for single measurements showed that the best classification is obtained using femur head dimensions, with correct sexing rates between 84.8 % for the circumference and 87.8 % for the maximum diameter. The maximum length achieved a similarly high rate of correct classification with 86.5%, whereas the rate for the condylar width (80.6%) was somewhat lower. The potential of midshaft dimensions for sex estimation was substantially weaker (62.3 to 70.8 %). With regard to a multivariate analysis, a stepwise selection procedure favoured a combination of maximum length and vertical head diameter with 90.1 % being correctly classified. A combination of maximum length, maximum head diameter and maximum midshaft diameter resulted in an even higher rate of 91.5 %. These Austrian standards may provide additional possibilities for sexing unknown bodies and skeletal remains born in the 19th to the middle of the 20th century.
机译:人体骨骼或骨骼碎片的性别估算对于未知物体的识别过程至关重要。区域差异和长期变化导致针对不同人群的骨测量标准不断变化。这项研究提供了1822年至1949年之间出生的奥地利人的股骨尺寸,并评估了判别分析所开发的性别估计功能的辨别力。根据保存状态的不同,最多测量了127名成年人的股骨(72名女性和55名男性)。获得以下平均值和标准偏差:最大长度(公头:449.7 +/- 16.7毫米,母头:413.9 +/- 16.3毫米),头围(148.5 +/- 7.8与133.8 +/- 6.4毫米),垂直(46.9 +/- 2.4 vs. 41.9 +/- 2.1 mm),横向(46.3 +/- 2.4 vs.41.5 +/- 2.0 mm)和最大头部直径(47.0 +/- 2.3 vs.42.0 +/- 2.1毫米),sa骨(28.3 +/- 2.2 vs. 26.2 +/- 1.8 mm),横向(27.9 +/- 2.5 vs. 26.1 +/- 2.0 mm)和最大中轴直径(29.2 +/- 2.1 2 27.3 +/- 1.6毫米)和width突宽度(79.6 +/- 4.6与71.9 +/- 3.8毫米)。对单次测量的(交叉验证)判别分析表明,使用股骨头尺寸可获得最佳分类,正确的性别比在圆周上为84.8%,最大直径为87.8%。最大长度的正确分类率达到了类似的高比率,为86.5%,而width突宽度的比率(80.6%)略低。性别估计中轴尺寸的潜力明显较弱(62.3%至70.8%)。关于多变量分析,逐步选择过程有利于最大长度和垂直杆头直径的组合,正确分类为90.1%。最大长度,最大缸盖直径和最大中间轴直径的组合产生了甚至更高的91.5%的比率。这些奥地利标准可能为在20世纪19至20世纪中叶出生的未知尸体和骨骼遗骸进行性别鉴定提供了其他可能性。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号