首页> 外文期刊>Analytical chemistry >Chip-based solid-phase extraction pretreatment for direct electrospray mass spectrometry analysis using an array of monolithic columns in a polymeric substrate
【24h】

Chip-based solid-phase extraction pretreatment for direct electrospray mass spectrometry analysis using an array of monolithic columns in a polymeric substrate

机译:基于芯片的固相萃取预处理,使用聚合物基质中的整体柱阵列进行直接电喷雾质谱分析

获取原文
获取原文并翻译 | 示例
           

摘要

An array of eight porous monolithic columns, prepared in a Zeonor polymeric chip by UV-initiated polymerization of butyl methacrylate and ethylene dimethacrylate, was tested for solid-phase extraction (SPE) cleanup of biological samples prior to directly coupled electrospray mass spectrometry (ESI-MS). The chip, fabricated by hot embossing and thermal bonding, consists of eight parallel channels (10 mm long, 360 mum i.d.) connected via external fused-silica capillaries. The monomer mixture was aspirated simultaneously into the eight channels using a homemade vacuum manifold device and polymerized in parallel for 20 min under UV irradiation. The porous monolithic columns were then characterized by scanning electron microscopy and evaluated by ESI-MS applications with respect to sample capacity, recovery, reproducibility of peak area or peak height ratios, and linearity between peak height ratio and concentration using imipramine as a pharmaceutical test compound. The average sample capacity was estimated to be 0.30 mug with a relative standard deviation (RSD) of 26.5% for the eight monolithic columns on the same polymeric chip. For two chips prepared using the same monomer mixture, the difference in average sample capacity was 7.0%. The average recovery for the eight monolithic SPE columns on the same chip was 79.1% with an RSD of 7.9%. Using imipramine-d3 as an internal standard, the RSD of peak height ratios for the eight different columns was 2.0% for a standard solution containing 1 mug/mL imipramine. A linear calibration curve (R-2 = 0.9995) was obtained for standard aqueous solutions of imipramine in the range from 0.025 to 10 mug/mL. To demonstrate the analytical potential of the chip-based SPE system, two different types of real-world samples including human urine sample and P450 drug metabolism incubation mixture were tested. Similar to standard aqueous solution, a linear correlation (R2 = 0.9995) was also found for human urine sample spiked with imipramine in the range of 0.025-10 mug/mL When aliquots of a human urine sample spiked with 1 mug/mL imipramine were loaded onto eight different monolithic columns, the RSD of peak height ratios was 3.8%. For a P450-imipramine incubation mixture, the formation of the N-demethylated metabolite (m/z 267.2) and the monohydroxylated metabolite (m/z 297.2) of imipramine was observed following chip-based monolithic SPE sample cleanup and preconcentration. [References: 28]
机译:测试了在Zeonor聚合物芯片中通过甲基丙烯酸丁酯和二甲基丙烯酸乙烯酯的UV引发聚合制备的八个多孔整体式色谱柱的阵列,在直接偶联电喷雾质谱(ESI-多发性硬化症)。该芯片是通过热压花和热粘合制成的,由八个平行的通道(长10毫米,内径360毫米)组成,这些通道通过外部熔融石英毛细管连接。使用自制的真空歧管装置将单体混合物同时吸入八个通道,并在紫外线辐射下平行聚合20分钟。然后,通过扫描电子显微镜对多孔整体柱进行表征,并通过ESI-MS应用进行评估,以样品容量,回收率,峰面积或峰高比的重现性以及使用丙咪嗪作为药物测试化合物的峰高比与浓度之间的线性。对于同一聚合物芯片上的八个整体柱,平均样品容量估计为0.30马克杯,相对标准偏差(RSD)为26.5%。对于使用相同单体混合物制备的两个芯片,平均样品容量之差为7.0%。同一芯片上的八个整体式SPE色谱柱的平均回收率为79.1%,RSD为7.9%。使用丙咪嗪-d3作为内标,对于包含1杯/ mL丙咪嗪的标准溶液,八个不同色谱柱的峰高比的RSD为2.0%。丙咪嗪标准水溶液的线性校准曲线(R-2 = 0.9995)为0.025至10杯/毫升。为了证明基于芯片的SPE系统的分析潜力,测试了两种不同类型的真实世界样本,包括人尿样本和P450药物代谢孵育混合物。与标准水溶液相似,加标了0.025-10杯/毫升的加有异丙酚的人尿液样品也发现线性相关性(R2 = 0.9995)在八个不同的整体柱上,峰高比的RSD为3.8%。对于P450-丙咪嗪孵育混合物,在基于芯片的整体式SPE样品净化和预浓缩后,观察到丙咪嗪的N-去甲基化代谢物(m / z 267.2)和单羟基化代谢物(m / z 297.2)形成。 [参考:28]

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号