...
首页> 外文期刊>Medical and Biological Engineering and Computing: Journal of the International Federation for Medical and Biological Engineering >Control of standing balance at leaning postures with functional neuromuscular stimulation following spinal cord injury
【24h】

Control of standing balance at leaning postures with functional neuromuscular stimulation following spinal cord injury

机译:脊髓损伤功能神经肌肉刺激倾斜姿势的控制

获取原文
获取原文并翻译 | 示例
           

摘要

This study systematically explored the potential of applying feedback control of functional neuromuscular stimulation (FNS) for stabilizing various erect and leaning standing postures after spinal cord injury (SCI). Perturbations ranging from 2 to 6% body weight were applied to two subjects with motor complete thoracic level SCI who were proficient at standing with implanted multichannel neural stimulators to activate the ankle, knee, hip and trunk muscles. The subjects stood with four different postures: erect, forward, forward-right and forward-left. Repeatable and controlled perturbations were applied in the forward, backward, rightward and leftward directions by linear actuators pulling on ropes attached to the subjects via a belt worn just above the waist. Upper extremity (UE) forces exerted on a stationary walker were measured with load cells attached to the handles. A feedback controller based on center of pressure (CoP) varied the stimulation levels to the otherwise paralyzed muscles so as to resist the effects of the perturbations. The effect of the feedback controller was compared to the case where only open-loop baseline stimulation was applied. This was done in terms of: (a) maximum resultant UE force exerted by the subjects on the walker, (b) maximum resultant CoP overshoot and (c) CoP root-mean-square deviation (RMSD). Feedback control resulted in significant reductions in the mean values of the majority of outcome values compared to baseline open-loop stimulation. Maximum resultant UE force was reduced by as much as 50% in one of the postures for one of the subjects. RMSD and maximum CoPs were reduced by as much as 75 and 70%, respectively, with feedback control. These results indicate that feedback control can be used to reject destabilizing disturbances in individuals with SCI using FNS not only for erect postures but also for leaning postures typically adopted during reaching while attempting various activities of daily living.
机译:本研究系统地探讨了应用功能性神经肌肉刺激(FNS)反馈控制的可能性,以稳定脊髓损伤后的各种直立和倾斜姿势(SCI)。从2到6%的体重范围内的扰动都适用于两个受试者,其中两个受试者具有机动完整的胸部水平SCI,他熟练地站在植入的多通道神经刺激器中,激活脚踝,膝盖,臀部和躯干肌肉。受试者与四种不同的姿势站起来:直立,向前,向前和向前左右。通过在沿腰部上方磨损的皮带上拉动连接到受试者的绳索的线性致动器,在向前,向后,向右和向左方向上施加可重复和控制的扰动。用连接到手柄的载荷单元测量施加在固定步行者上的上肢(UE)力。基于压力中心(COP)的反馈控制器将刺激水平变化到其他瘫痪的肌肉,以抵抗扰动的影响。将反馈控制器的效果与仅应用开环基线刺激的情况进行了比较。这是根据以下的方式完成的:(a)由沃克上的受试者施加的最大结果UE力,(b)最大结果警察过冲和(c)支付Cop根均方偏差(RMSD)。与基线开环刺激相比,反馈控制导致大多数结果值的平均值下降。在其中一个受试者的姿势中,最大结果UE力减小多达50%。 RMSD和最大COPS分别减少多达75%和70%,具有反馈控制。这些结果表明,反馈控制可用于拒绝使用SCI的个体中的个体中的稳定性干扰,不仅可以用于竖立姿势​​,而且还用于在尝试各种日常生活活动期间达到的倾斜姿势。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号