Electrostatic compensation of structural imperfections in dynamically amplified dual-mass gyroscope

摘要

This paper presents a study on dynamics of a dual-mass MEMS vibratory gyroscope in presence of fabrication imperfections and reports a method for precision electrostatic frequency tuning of the operational modes. A number of multi-mass MEMS gyroscopes have emerged in recent years pursuing different goals, such as dynamically balanced structure, increased bandwidth, and dynamic amplification. Along with many perceived advantages of multi-mass devices, several challenges associated with mode-matching in a system with increased number of degrees-of-freedom (DOF) have to be considered. This work shows that it is possible to apply the DC tuning techniques, similar to tuning a conventional single-mass gyroscope, to achieve the precision tuning in a dual-mass sensor, without losing advantages of increased DOF of the system. The presented frequency trimming technique is based on assessing the modes mismatch and cross-coupling between modes by means of fitting the experimental frequency response curves to the analytical solutions of the dual-mass system in presence of imperfections. The tuning algorithm involves two steps. First, the stiffness mismatch along the two axes and the anisoelasticity angles a and 13 are identified, then the tuning DC voltages for modification of diagonal, off-diagonal, and coupling terms in the stiffness matrix are chosen. The method of electrostatic tuning was validated through the experimental characterization of a dual-mass dynamically amplified gyroscope, where the coupling between the two operational modes was minimized and frequency split was reduced from 26 Hz down to 50 mHz, resulting in 17.5 x increase in the gyroscope scale factor and significantly improved noise characteristics. The presented electrostatic compensation method is suitable for both off-line and on-line calibration. (C) 2018 Elsevier B.V. All rights reserved.