首页> 外文期刊>Surface & Coatings Technology >Properties of In-, Ga-, and Al-doped ZnO films grown by aerosol-assisted MOCVD: Influence of deposition temperature, doping level and annealing
【24h】

Properties of In-, Ga-, and Al-doped ZnO films grown by aerosol-assisted MOCVD: Influence of deposition temperature, doping level and annealing

机译:气溶胶辅助MOCVD法生长In,Ga和Al掺杂的ZnO薄膜的性能:沉积温度,掺杂水平和退火的影响

获取原文
获取原文并翻译 | 示例
           

摘要

In-, Ga- and Al-doped ZnO films were grown via the aerosol-assisted MOCVD technique using the following airstable metal-organic precursors: Zn(thd)(2), In(thd)(3), Al(thd)(3) and Ga(acac)(3) (thd = 2,2,6,6-tetramethy1-3,5-heptanedione, acac = acetylacetonate). Solution of a precursor mixture in 1,2-dimethoxyethane was transformed into an aerosol via ultrasound (2.56 MHz), and then the aerosol was transported into the deposition zone by N-2 + O-2 gas. The depositions were performed at 350-600 degrees C. The influences of the substrate, the deposition temperature, the doping element and the doping level on the structural, and the electrical and optical properties of the films were investigated using various characterisation techniques: XRD, SEM, AFM, UV-Vis and FT-IR spectroscopies, and Hall measurements. Epitaxial films on sapphire-R substrates exhibited the best electrical properties. Films doped by Ga and Al had lower resistivity compared to In-doped films. The best Ga- and Al-doped ZnO films (similar to 150-200 nm thick) grown on sapphire-R at 400 degrees C exhibited a resistivity of approximate to(7-8) x 10(-4) Omega cm, a carrier concentration of approximate to 1.5 x 10(20) cm(-3) and a relatively high carrier mobility of approximate to 50-60 cm(2) V-1 s(-1). Because the low resistivity of Ga- and Al-doped films was mainly determined by the high carrier mobility, the optical transmittance (T) was high in both the visible (T> 90%) and the mid-IR spectral ranges (T approximate to 90% at lambda = 2.5 mu m). High transmittance in the mid-IR spectral range makes these films suitable for use as transparent electrodes in applications of the IR optoelectronic devices. Annealing of the films for 30 min at 400 degrees C in an Ar + H-2 (10%) mixture markedly increased the carrier concentration, which resulted in the increase in the optical band gap (up to approximate to 3.5 eV) and in the decrease in film resistivity and transparency in the mid-IR spectral range. Annealed Al- and Ga-doped films exhibited a resistivity of approximate to(4 - 6) x 10(-4) Omega cm. (c) 2014 Elsevier B.V. All rights reserved.
机译:In-,Ga和Al掺杂的ZnO膜通过气溶胶辅助MOCVD技术生长,使用以下空气稳定的金属有机前体:Zn(thd)(2),In(thd)(3),Al(thd)( 3)和Ga(acac)(3)(thd = 2,2,6,6-四甲基1-3,5-庚二酮,acac =乙酰丙酮)。将前体混合物在1,2-二甲氧基乙烷中的溶液通过超声(2.56MHz)转化为气雾剂,然后通过N-2 + O-2气体将气雾剂输送到沉积区中。沉积在350-600摄氏度下进行。使用各种表征技术研究了衬底,沉积温度,掺杂元素和掺杂水平对薄膜的结构以及电学和光学性质的影响。 SEM,AFM,UV-Vis和FT-IR光谱仪以及霍尔测量。蓝宝石-R衬底上的外延膜表现出最佳的电性能。与In掺杂的薄膜相比,Ga和Al掺杂的薄膜的电阻率较低。在蓝宝石-R上于400摄氏度下生长的最佳Ga和Al掺杂的ZnO薄膜(类似于150-200 nm厚)表现出的电阻率约为(7-8)x 10(-4)Ωcm,是载体浓度约为1.5 x 10(20)cm(-3),并且载流子迁移率较高,约为50-60 cm(2)V-1 s(-1)。由于Ga和Al掺杂薄膜的低电阻率主要由高载流子迁移率决定,因此在可见光(T> 90%)和中红外光谱范围内(T约等于λ= 2.5微米时为90%)。在中红外光谱范围内的高透射率使这些薄膜适合用作红外光电设备应用中的透明电极。在Ar + H-2(10%)混合物中在400摄氏度下将薄膜退火30分钟,显着提高了载流子浓度,这导致了光学带隙的增加(高达约3.5 eV)和光学带隙的增加。降低中红外光谱范围内的薄膜电阻率和透明度。退火的铝和镓掺杂薄膜的电阻率约为(4-6)x 10(-4)Ω·cm。 (c)2014 Elsevier B.V.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号