首页> 外文期刊>Polymer: The International Journal for the Science and Technology of Polymers >The kinetic study of the curing reaction of mono- and di-epoxides obtained during the reaction of divinylbenzene and hydrogen peroxide with acid anhydrides
【24h】

The kinetic study of the curing reaction of mono- and di-epoxides obtained during the reaction of divinylbenzene and hydrogen peroxide with acid anhydrides

机译:二乙烯基苯和过氧化氢与酸酐反应过程中获得的单环氧化物和二环氧化物的固化反应的动力学研究

获取原文
获取原文并翻译 | 示例
           

摘要

In this paper, the non-isothermal differential scanning calorimetry (DSC) was employed to investigate the cure process and to determine the kinetic parameters of the curing reactions of mono- and di-epoxides with maleic and glutaric anhydrides. The epoxides were obtained during the epoxidation process of commercially available divinylbenzene by using 60% hydrogen peroxide as the oxidant in the presence of organic solvents and magnesium oxide as the catalyst. It was found that the cure process of epoxides with maleic anhydride was described through higher values of enthalpy of polymerization (Delta H-R) and lower temperatures of the cure initiation (T-onset), the peak maximum temperature (T-max) and the final cure temperature (T-end). It can be considered to accelerate the rate of reaction and lead to an excellent network structure when maleic anhydride was used as curing agent. The kinetic analysis was firstly computed using a model free-estimation of the activation energy (Friedman, Ozawa-Flynn-Wall methods) and then the multivariate non-linear regression with a 6th degree Runge-Kutta process in a modified Marquardt procedure was employed to calculate the corresponding kinetic parameters (E-i, n(i), A(i)) using the nth-order reaction f(alpha). The unbranched three-step process of the nth-order reaction f(alpha) for each step was the best to describe the cure process of mono- and di-epoxide with acid anhydrides. The determined values of the activation energies were in the range 64.7-105.2 kJ/mol for epoxides/glutaric anhydride system and 64.7-82.7 kJ/mol when maleic anhydride was used as hardening agent. (c) 2006 Elsevier Ltd. All rights reserved.
机译:本文采用非等温差示扫描量热法(DSC)研究了固化过程并确定了单环氧化物和二环氧化物与马来酸酐和戊二酸酐的固化反应动力学参数。在可商购获得的二乙烯基苯的环氧化过程中,通过在有机溶剂和氧化镁作为催化剂存在下,使用60%过氧化氢作为氧化剂来获得环氧化物。发现通过较高的聚合焓值(HRΔ)和较低的固化引发温度(T起始),最高峰值温度(T-max)和最终温度来描述环氧化物与马来酸酐的固化过程。固化温度(T端)。当使用马来酸酐作为固化剂时,可以认为它可以加快反应速度并导致优异的网络结构。首先使用活化能的模型自由估计(Friedman,Ozawa-Flynn-Wall方法)来计算动力学分析,然后在改进的Marquardt程序中采用带有6度Runge-Kutta过程的多元非线性回归来计算动力学分析。使用n阶反应f(alpha)计算相应的动力学参数(Ei,n(i),A(i))。每一步的n阶反应f(α)的直链三步过程最能描述酸酐与单环氧化物和二环氧化物的固化过程。对于环氧化物/戊二酸酐体系,活化能的测定值在64.7-105.2kJ / mol的范围内,而当使用马来酸酐作为硬化剂时,活化能的测定值在64.7-82.7kJ / mol的范围内。 (c)2006 Elsevier Ltd.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号