Fracture mechanical characterisation of mixed-mode toughness of thermoplast/glass interfaces

摘要

According to studies conducted by e.g. Liechti and Chai [J. Appl. Mech, 58 (1991) 680], Yuuki et al. [Eng. Fract. Mech. 47 (3) (1994) 367] and Ikeda and Miyazaki [Eng. Fract. Mech. 59 (6) (1998) 725], a significant increase of interfacial toughness is observed, whenever the magnitude of the bond tangential shear load of the asymptotic elastic mixed-mode state is increased in either direction. Between these extremes the interfacial toughness curve exhibits a pronounced minimum, which according to Hutchinson and Suo [Mater. Sci. Eng. A 107 (1989) 135] is believed to represent the so-called intrinsic adhesion, i.e. the failure toughness under pure local model I loading. Within linear elasticity, the biaxial, singular near-tip solution for an open interface crack may be employed for characterising the local stress state as long as non-linearities such as, e.g. crack-wall contact and plastic flow are contained within a zone small enough compared to the extension of the singular opening-dominated fields. Then, the critical stress state is given in terms of bimaterial stress intensity factors K_(1, c), K_(2, c) and the fracture toughness under mixed-mode loading may be expressed in terms of the critical energy release rate as a function of the mode-mixity ψ = tan~(-1) K_(2, c)/K_(1, c). The stress intensities have to be extracted from a stress analysis of the specimen under the critical load, which in the present work is performed by means of an FE-model of the loaded sample.