...
首页> 外文期刊>Journal of the Brazilian Chemical Society >Sodium Dodecyl Sulfate-Coated Alumina and C-18 Cartridge for the Separation and Preconcentration of Cationic Surfactants Prior to their Quantitation by Spectrophotometric Method
【24h】

Sodium Dodecyl Sulfate-Coated Alumina and C-18 Cartridge for the Separation and Preconcentration of Cationic Surfactants Prior to their Quantitation by Spectrophotometric Method

机译:分光光度法定量定量阳离子表面活性剂前用十二烷基硫酸钠包覆的氧化铝和C-18柱进行分离和预浓缩

获取原文
获取原文并翻译 | 示例
           

摘要

A new solid phase extraction method has been developed to the separation and preconcentration of trace amounts of cationic surfactants i.e. dodecyltrimethylammonium bromide (DTAB), cetyltrimethylammonium bromide (CTAB) and cetylpyridinium chloride (CPC). This method is based on the sorption of anionic surfactant (AS(-)) of sodium dodecyl sulfate (SDS) on the gamma-alumina surface and C-18 cartridge is used for preconcentration of cationic surfactants (CS+). Spectrophotometric determination method used for the determination of cationic surfactants is based on the competition between the cationic dye of methylene blue (MB+) and CS+ for association complex formation with SDS. The MB+ in the ion associate complex can be quantitatively substituted by CS+ leading to an increase in the absorbance measured at 662 nm. Optimum experimental conditions for separation, preconcentration and determination of cationic surfactants have been reported. Under the selected optimal conditions, preconcentration factor of two-fold was achieved and the results showed that determination of CPC, DTAB and CTAB could be performed in concentration ranges of 1 x 10(-5)-2 x 10(-4), 4 x 10(-5)-5 x 10(-4) and 5 x 10(-5)-5 x 10(-4) mol L-1, respectively. Eleven determinations of 10.0 mg mL(-1) of CPC, DTAB and CTAB solutions led to RSD's of 4.3, 3.7 and 4.0%, respectively. Method was validated using a set of different samples containing cationic surfactants.
机译:已开发出一种新的固相萃取方法来分离和预富集痕量的阳离子表面活性剂,即十二烷基三甲基溴化铵(DTAB),十六烷基三甲基溴化铵(CTAB)和十六烷基氯化吡啶鎓。该方法基于十二烷基硫酸钠(SDS)的阴离子表面活性剂(AS(-))在γ-氧化铝表面上的吸附,并且使用C-18柱对阳离子表面活性剂(CS +)进行预浓缩。用于测定阳离子表面活性剂的分光光度测定方法是基于亚甲基蓝(MB +)和CS +阳离子染料之间与SDS缔合形成复合物的竞争。离子缔合络合物中的MB +可以被CS +定量取代,从而导致在662 nm处测量的吸光度增加。已经报道了用于分离,预浓缩和测定阳离子表面活性剂的最佳实验条件。在所选的最佳条件下,实现了两倍的预浓缩因子,结果表明,可以在1 x 10(-5)-2 x 10(-4),4的浓度范围内进行CPC,DTAB和CTAB的测定。分别为x 10(-5)-5 x 10(-4)和5 x 10(-5)-5 x 10(-4)mol L-1。十一次测定10.0 mg mL(-1)的CPC,DTAB和CTAB溶液的RSD分别为4.3%,3.7%和4.0%。使用一组包含阳离子表面活性剂的不同样品验证了该方法。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号