首页> 外文期刊>Journal of Pharmaceutical and Biomedical Analysis: An International Journal on All Drug-Related Topics in Pharmaceutical, Biomedical and Clinical Analysis >A validated GC-MS method for the determination and quantification of residual solvents in counterfeit tablets and capsules
【24h】

A validated GC-MS method for the determination and quantification of residual solvents in counterfeit tablets and capsules

机译:一种经过验证的GC-MS方法,用于测定和定量假冒片剂和胶囊中的残留溶剂

获取原文
获取原文并翻译 | 示例
           

摘要

A fast headspace GC-MS method was developed and validated for the detection and quantification of residual solvents of all three ICH-classes in counterfeit tablets and capsules. The method was validated for 10 solvents, selected based on an initial screening of counterfeit medicinal products. The considered solvents were ethanol, 2-propanol, acetone, ethylacetate, chloroform, carbon tetrachloride, benzene, toluene, dichloromethane and ethylbenzene. The proposed method uses a Phenomenex 624 capillary column (60. m × 0.32. mm; 1.8μm film thickness) (Phenomenex, Torrance, USA) with an oven temperature program from 60°C (held for 5. min) to 270°C at 25°C/min. 270°C is held for 10. min. The total run time is 23.4. min.The obtained method was fully validated by applying the " total error" profile. Calibration lines for all components were linear within the studied ranges. The relative bias and the relative standard deviations for all components were smaller than 5%, the β-expectation tolerance limits did not exceed the acceptance limits of ±10% and the relative expanded uncertainties were acceptable for all of the considered components.A method was obtained for the screening and quantification of residual solvents in counterfeit tablets and capsules, which will allow a fast screening of these products for the presence of residual solvents.
机译:建立了快速顶空GC-MS方法,并验证了该方法可用于检测和定量假冒片剂和胶囊剂中所有三种ICH类的残留溶剂。该方法针对10种溶剂进行了验证,这些溶剂是根据对假药产品的初步筛选选择的。所考虑的溶剂为乙醇,2-丙醇,丙酮,乙酸乙酯,氯仿,四氯化碳,苯,甲苯,二氯甲烷和乙苯。所提出的方法使用Phenomenex 624毛细管柱(60.m×0.32.mm;膜厚1.8μm)(Phenomenex,Torrance,USA),柱箱温度程序设定为60°C(保持5分钟)至270°C在25°C / min下270℃保持10分钟。总运行时间为23.4。 min.min。通过应用“总误差”配置文件完全验证了所获得的方法。在研究范围内,所有组件的校准线均为线性。所有组件的相对偏差和相对标准偏差均小于5%,β预期公差极限不超过±10%的可接受极限,并且所有考虑的组件的相对扩展不确定度均可接受。用于筛选和定量假冒片剂和胶囊中残留溶剂的方法,可以快速筛查这些产品中是否存在残留溶剂。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号