首页> 外文期刊>Journal of biomaterials science >Fibrinogen and von Willebrand factor mediated platelet adhesion to polystyrene under flow conditions
【24h】

Fibrinogen and von Willebrand factor mediated platelet adhesion to polystyrene under flow conditions

机译:纤维蛋白原和von Willebrand因子介导血小板在流动条件下与聚苯乙烯的粘附

获取原文
获取原文并翻译 | 示例
获取外文期刊封面目录资料

摘要

The roles of adsorbed fibrinogen (Fg) and von Willebrand factor (VWF) in mediating platelet adhesion to synthetic surfaces under flow were investigated using polystyrene (PS) as a model hydrophobic surface. We measured platelet adhesion to PS pre-adsorbed with Fg, VWF, normal plasma, afibrinogenemic plasma, VWF-deficient plasma and deficient plasmas with various concentrations of added Fg or VWF. Platelets in a red blood cell suspension were passed through a flow chamber at either low (50 or 100 s(-1)) or high (500 or 1000 s(-1)) shear. Adhesion to PS preadsorbed with afibrinogenemic plasma was very low under both low and high shear conditions, but was restored in a dose-dependent manner with addition of Fg. Less than 20 ng/cm(2) of adsorbed Fg was sufficient to support full-scale platelet adhesion under flow. At high shear rate, platelet adhesion on PS pre-adsorbed with VWF-deficient plasma was much less than on PS pre-adsorbed with normal plasma, but adhesion to PS pre-adsorbed with VWF-deficient plasma with added VWF was very similar to adhesion to PS pre-adsorbed with normal plasma. At low shear, adhesion to PS pre-adsorbed with VWF-deficient plasma was the same as on PS pre-adsorbed with normal plasma. As little as 1 ng/cm(2) of VWF adsorbed from plasma made platelet adhesion higher under high shear than under low shear. The effects of adsorbed Fg and VWF on the morphologies of platelets that adhered from suspensions flowing at high shear rates were also investigated. The lack of either Fg or VWF resulted in marked decreases in the extent of platelet spreading. Real-time observation of platelet adhesion under an epifluorescent microscope showed that platelets adhered to the surface in a linear pattern aligned in the direction of flow under high shear conditions.
机译:使用聚苯乙烯(PS)作为模型疏水性表面,研究了吸附的纤维蛋白原(Fg)和血管性血友病因子(VWF)在介导流动条件下介导血小板粘附于合成表面的作用。我们测量了血小板对预先吸附有Fg,VWF,正常血浆,血纤维蛋白原血浆,VWF缺乏血浆和血浆中Fg或VWF浓度不同的PS的粘附力。红细胞悬液中的血小板以低(50或100 s(-1))或高(500或1000 s(-1))剪切力通过流动室。在低和高剪切条件下,用纤维蛋白生成血浆预吸附的PS的粘合力都非常低,但是通过添加Fg以剂量依赖性的方式恢复。小于20 ng / cm(2)的吸附Fg足以支持流动下的全尺寸血小板粘附。在高剪切速率下,预先吸附有VWF缺陷血浆的PS上的血小板粘附力要比正常血浆预吸附的PS上的血小板粘附力小得多,但是添加了VWF的VWF缺陷血浆对预先吸附的PS的粘附力非常相似。到正常血浆中预吸附的PS。在低剪切下,对VWF缺陷血浆预吸附的PS的粘附力与正常血浆预吸附的PS的粘附力相同。从血浆中吸附的VWF少至1 ng / cm(2),使血小板在高剪切下的粘附力高于低剪切下的粘附力。还研究了吸附的Fg和VWF对在高剪切速率下流动的悬浮液粘附的血小板形态的影响。 Fg或VWF的缺乏导致血小板铺展程度的显着降低。在落射荧光显微镜下对血小板粘附的实时观察表明,血小板在高剪切条件下以线性模式排列在表面,该线性模式沿流动方向排列。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号