首页> 外文期刊>The Journal of Experimental Biology >Is a parallel elastic element responsible for the enhancement of steady-state muscle force following active stretch?
【24h】

Is a parallel elastic element responsible for the enhancement of steady-state muscle force following active stretch?

机译:平行弹性元件是否负责主动拉伸后稳态肌肉力量的增强?

获取原文
获取原文并翻译 | 示例
获取外文期刊封面目录资料

摘要

For over 50 years, it has been recognised that muscles from many different species of animals are able to generate a higher steady-state isometric force after active stretch than during a purely isometric contraction at the same length. This is known as ;residual force enhancement' (rFE). The mechanism underlying this phenomenon remains controversial. One proposal is that an elastic element parallel to the cross-bridges becomes stiffer, or is engaged, when the muscle is activated and generates force when stretched. If this is indeed the sole mechanism, then rFE should be eliminated by subsequently shortening the muscle by a distance equal to or greater than the initial stretch. We tested this hypothesis using six intact single fibres from frog lumbrical muscle. The fibres were activated and stretched to generate rFE and then rapidly shortened by between 25% and 700% of the initial stretch distance. In contrast to previous reports, we found that rapid shortening induced a depression of subsequent isometric force. We used two methods to account for this force depression when calculating rFE, thereby obtaining upper and lower bounds for the true rFE. With both methods of calculation, rFE was significantly greater than zero when shortening distance was equal to stretch distance (P=0.0004 and P=0.03, respectively). Therefore, our hypothesis was not supported. We conclude that rFE is unlikely to be generated solely by a parallel elastic element.
机译:50多年来,人们已经认识到,与相同长度的纯等距收缩相比,许多种不同动物的肌肉在主动拉伸后能够产生更高的稳态等距力。这称为“残余力增强”(rFE)。造成这种现象的机制仍存在争议。一种建议是,当肌肉被激活并在拉伸时产生力时,平行于跨桥的弹性元件会变硬或接合。如果这确实是唯一的机制,则应通过随后将肌肉缩短等于或大于初始伸展距离的距离来消除rFE。我们使用来自青蛙腰肌的六条完整的单纤维检验了这一假设。纤维被活化并拉伸以产生rFE,然后迅速缩短初始拉伸距离的25%至700%。与以前的报告相反,我们发现快速缩短会导致随后的等距力降低。在计算rFE时,我们使用了两种方法来解决这种力降低的问题,从而获得真实rFE的上限和下限。通过两种计算方法,当缩短距离等于拉伸距离时,rFE显着大于零(分别为P = 0.0004和P = 0.03)。因此,我们的假设不受支持。我们得出结论,rFE不可能仅由平行弹性元件产生。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号