Negative bending capacity prediction of composite girders based on continuous strength method

摘要

This paper investigates the ultimate negative bending capacity of composite plate girders, whose ultimate hogging flexural state is governed by the local buckling of the bottom flange of steel girders. The Continuous Strength Method, a deformation-based design approach, which employs a continuous relationship between cross-sectional slenderness and inelastic local buckling deformation capacity, is adopted to accurately predict the ultimate negative bending capacity of composite plate girders. A large number of composite cross-sections, which could represent the conventional cross-section of composite plate girder bridges with medium spans, are designed along with various combinations of steel girder strengths and rebar strengths. For each composite cross-section, its ultimate negative bending capacity based on CSM, ultimate elastic bending capacity, and rigid plastic bending capacity are calculated and compared mutually. Both linear and quadratic interpolation equations are proposed for simplifying the negative bending capacity prediction of the composite section. The analysis results indicate that the linear interpolation bending capacity predicting equation can produce relatively conservative results for most Class 2 and Class 3 cross-sections but the equation is quite concise for application. The quadratic interpolation bending capacity predicting equation can offer more accurate results, especially for cross-sections of which the bottom flange governs the ultimate elastic flexural state rather than the rebar in concrete slabs. The rebar in concrete slabs, the top flange and bottom flange of steel girders are supposed to enter into yield state simultaneously for improving the elastic negative bending efficiency of the composite section. Meanwhile, the proposed quadratic interpolation equation could also provide an accurate negative bending capacity prediction.