首页> 外文期刊>Superlattices and microstructures >Characterization of emitted light from travelling Gunn domains in Al_(0.08)Ga_(0.92)As alloy based Gunn devices
【24h】

Characterization of emitted light from travelling Gunn domains in Al_(0.08)Ga_(0.92)As alloy based Gunn devices

机译:Al_(0.08)Ga_(0.92)As合金基于Gunn器件的行进Gunn畴的发射光的表征

获取原文
获取原文并翻译 | 示例

摘要

We report room temperature operation of light emitters based on Al_(0.08)Ga_(0.92)As Gunn devices fabricated in a simple bar geometry with wedged-shaped electrodes. Highspeed I-V measurements reveal that, at the threshold of negative differential resistance region at around 3.8 kV/cm, current instabilities, i.e., Gunn oscillations, are created with a 3.8 ns period. Both edge and surface light emission are observed when the device is biased at an electric field of onset of the negative differential resistance (NDR) region at around 3.8 kV/cm and the intensity of the light exponentially increases at applied fields just above NDR threshold likewise in a conventional laser. The origin of the light emission, which has peak wavelength is around 816 nm corresponds to the band-gap energy of Al_(0.08)Ga_(0.92)As, is recombination of electrons and holes generated by impact ionisation process in travelling space charge domains, i.e., Gunn domains. We demonstrate that, with increasing applied field, the amplitude of Gunn domains increases which is a result of the enhanced generation of electrons and holes via impact ionisation. The intensity of the emitted light is observed to be dependent on applied electric field. At low electric fields, light intensity increases linearly then, when applied electric field reaches the onset of NDR region, increases exponentially. Besides, as applied field is increased, full width at half maximum (FWHM) of emitted light decreases to 56.5 nm from 62 nm, evolving into higher selective emission line in wavelength. The light emission from the device is determined to be independent of the polarity of the applied voltage. A comparison of surface emission and edge emission characteristics of the waveguided device are different from each other. Edge emission has higher electroluminescence intensity and better spectral purity than surface emission with well-defined longitudinal modes of Fabry-Perot cavity, which indicates that, in such a device, lasing action arises from the recombination of excess carriers generated via impact ionisation in travelling Gunn domains. Besides, the edge emission peak of waveguided Al_(0.08)Ga_(0.92)As Gunn device at 4.1 kV/cm is split into two peaks with FWHM of 8 and 6 nm as well as neighbouring sharper minor peaks due to stimulated emission dominates by building-up photons in the cavity. Our results reveal that the proposed Gunn device can be a promising alternative to conventional diode lasers with its simpler design, only one type doped active region and voltage polarity-independent operation, but the duty cycle has to be chosen small enough to make the device operate at room temperature.
机译:我们报告了基于Al_(0.08)Ga_(0.92)As Gunn器件的发光器在室温下的运行情况,这些器件是用带有楔形电极的简单条形结构制造的。高速I-V测量表明,在负差分电阻区域的阈值约为3.8 kV / cm时,会以3.8 ns的周期产生电流不稳定性,即Gunn振荡。当器件在大约3.8 kV / cm的负微分电阻(NDR)区域的起始电场处偏置时,观察到边缘和表面发光,并且光强在正好高于NDR阈值的施加场上也呈指数增长在常规激光器中。峰值波长约为816 nm的光的起源对应于Al_(0.08)Ga_(0.92)As的带隙能,是电子和空穴在行进空间电荷域中通过碰撞电离过程产生的复合,即Gunn域。我们证明,随着施加电场的增加,Gunn域的振幅增加,这是由于电子和空穴通过碰撞电离产生的增强而导致的。观察到所发射的光的强度取决于所施加的电场。在低电场下,光强度呈线性增加,然后,当施加的电场到达NDR区域开始时,呈指数增加。此外,随着施加场的增加,发射光的半峰全宽(FWHM)从62 nm减小到56.5 nm,演变为波长更高的选择性发射线。确定从设备发出的光与所施加电压的极性无关。波导装置的表面发射特性和边缘发射特性的比较彼此不同。边缘发射具有比表面发射更高的电致发光强度和更好的光谱纯度,而表面发射具有明确定义的Fabry-Perot腔纵向模式,这表明,在这种设备中,激射作用是由于在行进的Gunn中通过碰撞电离产生的多余载流子的重组而产生的域。此外,波导Al_(0.08)Ga_(0.92)As Gunn器件在4.1 kV / cm处的边缘发射峰被分成两个峰,其FWHM分别为8和6 nm,以及由于受激发射而形成的相邻较窄的次要峰,主要是由于建筑物腔中的向上光子。我们的结果表明,所提出的Gunn器件具有更简单的设计,仅一种类型的有源区域和与电压极性无关的工作方式,可以替代传统的二极管激光器,但是占空比必须选择得足够小才能使该设备工作在室温下。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号