首页> 外文期刊>Journal of food process engineering >Mathematical Modeling of Low Temperature High Velocity (LTHV) Drying in Foods
【24h】

Mathematical Modeling of Low Temperature High Velocity (LTHV) Drying in Foods

机译:食品低温高速干燥(LTHV)的数学建模

获取原文
获取原文并翻译 | 示例
       

摘要

The main purpose of this study is the mathematical modeling of low temperature and high velocity (LTHV) drying method with different temperatures and its comprehensive evaluations in fish. For this purpose, 200g of trout (Oncorhynchus mykiss) was dried with a single layer dryer by using 7m/s air velocity and approximate to 40-50% relative humidity at 4, 10, 15 and 20 degrees C. Based on the experiments, weight loss (percentage), final moisture content and drying times were determined. Twenty-three different mathematical models were applied to the observed data to perform a nonlinear regression analysis and the result was comprehensively evaluated by using 14 evaluation criteria. Moreover, the exponential forms of thin-layer drying curves of fish samples were derived. Consequently, the most suitable mathematical models were selected for the LTHV drying conditions considering evaluation criteria. In this regard, the most suitable six models (Logarithmic, Midilli-Kucuk, Demir et al., Hii et al., Balbay-Sahin and Alibas) were selected for the LTHV drying at 4 degrees C that is the most suitable drying temperature for food quality. After comprehensive evaluations, it was understood that some of the evaluation criteria give same results in similar drying conditions as the residual sum of squares (RSS), total sum of squares (SST) and sum of squares (SSE).
机译:这项研究的主要目的是对不同温度下的低温和高速(LTHV)干燥方法进行数学建模,并对鱼类进行综合评估。为此,将200 g鳟鱼(Oncorhynchus mykiss)用7m / s的风速在4、10、15和20摄氏度下以7m / s的风速和大约40-50%的相对湿度进行干燥。基于实验,确定重量损失(百分比),最终水分含量和干燥时间。将二十三个不同的数学模型应用于观测数据以进行非线性回归分析,并使用14个评估标准对结果进行了综合评估。此外,得出了鱼类样品薄层干燥曲线的指数形式。因此,考虑到评估标准,为LTHV干燥条件选择了最合适的数学模型。在这方面,选择了最合适的六个模型(对数,Midilli-Kucuk,Demir等,Hii等,Balbay-Sahin和Alibas)在4摄氏度下进行LTHV干燥,这是最适合的干燥温度。食物品质。经过全面评估后,可以理解,某些评估标准在相似的干燥条件下得出的结果与残留平方和(RSS),平方和(SST)和平方和(SSE)相同。

著录项

  • 来源
    《Journal of food process engineering》 |2017年第2期|12378.1-12378.16|共16页
  • 作者

    Kilic Aydin;

  • 作者单位

    Recep Tayyip Erdogan Univ, Dept Food Engn, Fac Engn, TR-53100 Rize, Turkey;

  • 收录信息 美国《科学引文索引》(SCI);美国《工程索引》(EI);
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

  • 入库时间 2022-08-17 23:23:11

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号