...
首页> 外文期刊>Journal of Computational Electronics >Simulation and comparative analysis of the DC characteristics of submicron GaN HEMTs for use in CAD software
【24h】

Simulation and comparative analysis of the DC characteristics of submicron GaN HEMTs for use in CAD software

机译:CAD软件中使用的亚微米GaN HEMT直流特性的仿真和比较分析

获取原文
获取原文并翻译 | 示例

摘要

Bearing in mind the requirements of design engineers, a nonlinear model is developed to simulate the temperature-dependent I-V characteristics of submicron high-electron-mobility transistors (HEMTs). Self- and ambient heating effects are incorporated into the model expression to cater for both the negative and positive conductance of the device, after the onset of the saturation current. It is shown that the accuracy of numerical models previously developed for metal-semiconductor field-effect transistors (MESFETs) deteriorates when simulating the I-V characteristics of gallium nitride (GaN) HEMTs, primarily due to the self-heating effects. The validity of the proposed model is checked for GaN HEMTs with gate length (Lg) ranging from 0.12 to 0.7m in the temperature range of T=298 to T=773K. It is demonstrated that the proposed model simulates, with a good degree of accuracy, the output characteristics of such devices exhibiting negative conductance in the saturation region of operation. It is observed that, for devices exhibiting negative conductance in the saturation region, the peak transconductance (gm) occurs at a relatively higher negative gate bias while the peak value reduces with increasing ambient temperature. The root-mean-square errors reveal that the proposed model is better than other similar models reported in the literature, with an improvement varying from 17 to 50% depending on the device characteristics.
机译:考虑到设计工程师的要求,开发了一个非线性模型来模拟亚微米高电子迁移率晶体管(HEMT)随温度变化的I-V特性。在饱和电流开始后,将自热和环境热效应合并到模型表达式中,以适应器件的负电导和正电导。结果表明,在模拟氮化镓(GaN)HEMT的I-V特性时,先前为金属半导体场效应晶体管(MESFET)开发的数值模型的精度下降,这主要是由于自热效应。在T = 298至T = 773K的温度范围内,针对栅极长度(Lg)为0.12至0.7m的GaN HEMT,检查了所提出模型的有效性。证明了所提出的模型以良好的准确度模拟了这种器件的输出特性,这些器件在工作饱和区域表现出负电导。可以看出,对于在饱和区显示负电导率的器件,峰值跨导(gm)会在较高的负栅极偏置下发生,而峰值会随着环境温度的升高而降低。均方根误差表明,所提出的模型比文献中报道的其他类似模型更好,取决于器件的特性,其改进范围从17%到50%不等。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号