首页> 外文学位 >Using strong gravitationally lensed galaxies to probe the metallicity history of star-forming galaxies between redshift 1 and 3.
【24h】

Using strong gravitationally lensed galaxies to probe the metallicity history of star-forming galaxies between redshift 1 and 3.

机译:使用强力引力透镜星系探测红移1和3之间的恒星形成星系的金属历史。

获取原文
获取原文并翻译 | 示例

摘要

This thesis conducts the investigation into the metallicity history of galaxies between redshift 1 and 3, using gravitationally lensed galaxies. We use metallicity as a tool to understand the formation and evolution history of galaxies. We direct our research in two areas.;1. We combine our new sample of gravitationally lensed galaxies with existing lensed and non-lensed samples to conduct the largest investigation so far into the mass-metallicity (MZ) relation at z > 1. We apply a self-consistent metallicity calibration scheme to investigate the metallicity evolution of star-forming galaxies as a function of redshift. We find that at the median redshift of z = 2.07, the median metallicity of the lensed sample is 0.35 dex lower than the local SDSS star-forming galaxies and 0.18 dex lower than the z ∼ 0.8 DEEP2 galaxies. Our lensed sample shows a much larger metallicity range and scatter (> 0.2 dex) than the z ∼ 2 UV selected galaxies at similar masses. These offsets translate into a metallicity evolution of -0.23 ± 0.01 dex per unit redshift from z ∼ 0 → 1, and -0.14 ± 0.08 dex per unit redshift from z ∼ 1 → 3. A more rapid evolution is seen between z ∼ 1 → 3 (with a mean fall in metallicity of -0.05 ± 0.01 dex Gyr–1 ) than z ∼ 0 → 1 (-0.020 ± 0.001 dex Gyr–1). This evolution agrees with the most recent cosmological hydrodynamic simulations with momentum driven winds within the errors.;2. Combining the magnification power of gravitational lensing and AO-aided Integral Field Unit spectrographs (IFUs) is the only way to achieve sufficient signal-to-noise and angular resolution for spatially resolved metallicity studies. Using this technique, we present the first metallicity gradient measurement for a grand-design face-on spiral galaxy at z ∼ 1.5. The gradients of our spiral and another 2 lensed galaxies at z ∼ 2 are much steeper than local disk galaxies, supporting an “inside-out” galaxy formation scenario. We also report spatially resolved emission lines of a z ∼ 1 lensed galaxy. We find significant shock excitation due to galactic outflows. Our analysis suggests that shocked regions may mimic flat or inverted metallicity gradients at high redshift. We find that high angular resolution observations provide the most accurate metallicity gradient measurement, whereas seeing-limited studies under estimate the slope of the gradients.
机译:本文利用引力透镜星系对红移1和3之间的星系的金属历史进行了研究。我们使用金属性作为了解星系形成和演化历史的工具。我们将研究重点放在两个领域:1。我们将新的引力透镜星系样本与现有的透镜和非透镜样本相结合,以对z> 1时的质量-金属度(MZ)关系进行迄今为止最大的调查。我们采用自洽的金属度校准方案来调查恒星形成星系的金属性演变与红移的关系。我们发现,在z = 2.07的中值红移处,带透镜样品的中值金属度比本地SDSS恒星形成星系低0.35 dex,比z〜0.8 DEEP2星系低0.18 dex。我们的透镜样品显示出比相似质量的z〜2 UV选星系更大的金属范围和散射(> 0.2 dex)。这些偏移转化为从z〜0→1的每单位红移-0.23±0.01 dex,从z〜1→3的每单位红移-0.14±0.08 dex的金属度演变。在z〜1→之间可以看到更快的演变。 3(平均金属性下降-0.05±0.01 dex Gyr-1)比z〜0→1(-0.020±0.001 dex Gyr-1)低。这种演变与最新的宇宙流体力学模拟相符,其中动量驱动的风在误差范围内; 2。结合重力透镜的放大倍数和AO辅助积分场单元光谱仪(IFU),是获得足够的信噪比和角分辨率以进行空间分辨金属性研究的唯一方法。使用这种技术,我们提出了z〜1.5的大型设计的面对旋涡星系的首次金属度梯度测量。在z〜2处,我们的旋涡星系和另外两个带透镜的星系的梯度比本地圆盘星系陡峭得多,这支持“由内而外”的星系形成情况。我们还报告了z〜1透镜星系的空间分辨发射线。由于银河外流,我们发现了明显的激振。我们的分析表明,在高红移下,冲击区域可能模仿平坦或倒置的金属度梯度。我们发现,高角度分辨率的观测可以提供最准确的金属度梯度测量,而视线有限的研究则只能根据梯度的斜率进行估算。

著录项

  • 作者

    Yuan, Tiantian.;

  • 作者单位

    University of Hawai'i at Manoa.;

  • 授予单位 University of Hawai'i at Manoa.;
  • 学科 Physics Astrophysics.;Physics Astronomy and Astrophysics.
  • 学位 Ph.D.
  • 年度 2012
  • 页码 266 p.
  • 总页数 266
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号