首页> 外文会议>VLSI Design, Automation, and Test (VLSI-DAT), 2012 International Symposium on >Design and implementation of an optical OFDM baseband receiver in FPGA
【24h】

Design and implementation of an optical OFDM baseband receiver in FPGA

机译:FPGA中光OFDM基带接收机的设计与实现

获取原文
获取原文并翻译 | 示例

摘要

In this paper, a baseband receiver design and its FPGA implementation for an OOFDM system aimed at the NG-PON (passive optical network) applications are presented. A low cost IMDD (intensity modulation, direct detection) architecture is adopted and baseband DSP measures are employed to compensate various optical impairments. Targeting a 4GSps throughput rate, an 8-way parallel architecture is developed to perform the synchronization, FFT and equalization each with massive parallelism. A real valued FFT module taking advantage of the Hermitian spectrum is also developed to reduce the circuit complexity significantly. The simulation results show the proposed baseband receiver is capable of achieving an 8Gbps (effective) transmission bandwidth for 64-QAM coded OFDM symbols over a 25km long single mode fiber network. The uncoded BER reaches 10−3 when the received optical power is −16dBm. Due to the speed and resource limitation, the FPGA implementation obtains a fully functional but speed degraded system. The maximum working frequency is 250 MHz, which is one half of the 500MHz required for real time processing. The design occupies 21,423 logic slices and 56 embedded multiplier modules.
机译:本文针对面向NG-PON(无源光网络)应用的OOFDM系统,提出了一种基带接收机设计及其FPGA实现。采用低成本的IMDD(强度调制,直接检测)架构,并采用基带DSP措施来补偿各种光学损伤。针对4GSps的吞吐速率,开发了一种8路并行架构来执行同步,FFT和均衡,每个都具有大规模并行性。还开发了利用Hermitian频谱的实值FFT模块,以显着降低电路复杂度。仿真结果表明,所提出的基带接收机能够在25公里长的单模光纤网络上为64-QAM编码的OFDM符号实现8Gbps(有效)传输带宽。当接收的光功率为-16dBm时,未编码的BER达到10 -3 。由于速度和资源的限制,FPGA实现获得了功能齐全但速度下降的系统。最大工作频率为250 MHz,这是实时处理所需500MHz的一半。该设计占用21,423个逻辑片和56个嵌入式乘法器模块。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号