【24h】

Ion beam induced nucleation in amorphous GaAs layers during MeV implantation

机译:MeV注入过程中离子束诱导非晶GaAs层中的形核

获取原文
获取原文并翻译 | 示例

摘要

To investigate the nonlinear dose dependence of the thickness of the recrystallized layer during ion beam induced epitaxial recrystallization at amorphous/crystalline interfaces GaAs samples were irradiated with 1.0 MeV Ar~+, 1.6 MeV Ar~+ or 2.5 MeV Kr~+ ions using a dose rate of 1.4 X 10~12 cm~-2s~-1 at temperatures between 50 deg C and 180 deg C. It has been found that the thickness of the recrystallizaed layer reaches a maximum value at T_max=90 deg C and 135 deg C for the Ar~+ and Kr~+ implantations, respectively. This means that the crystallization rate deviates from an Arrhenius dependence due to ion beam induced nucleation and grwoth within the remaining amorphous layer. The size of the crystallites depends on the implantation dose. This nucleation and growth of the crystallites disturbes and at least blocks the interface movement because the remaining surface layer becomes polycrystalline. Choosing temperatures sufficiently below T_max the thickness of the recrystallized layer increases linearly with the implantation dose indicating that the irradiation temperature is too low for ion induced nucleation.
机译:为了研究在非晶/晶体界面上离子束诱导的外延重结晶过程中重结晶层厚度的非线性剂量依赖性,使用1.0 MeV Ar〜+,1.6 MeV Ar〜+或2.5 MeV Kr〜+离子辐照GaAs样品在50℃至180℃之间的温度下,其速率为1.4 X 10〜12 cm〜-2s〜-1。发现再结晶层的厚度在T_max = 90℃和135℃时达到最大值。分别用于Ar〜+和Kr〜+注入。这意味着由于离子束引起的成核作用和残留非晶层内的腐蚀,结晶速率偏离了阿伦尼乌斯依赖性。微晶的大小取决于注入剂量。微晶的这种成核和生长干扰并且至少阻止了界面运动,因为剩余的表面层变成了多晶。选择充分低于T_max的温度,重结晶层的厚度随注入剂量线性增加,这表明照射温度对于离子诱导的成核作用而言太低。

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号