Hot stamping of load adjusted structural parts Bernd-Arno Behrens, Anas Bouguecha,

摘要

The importance of high-strength steel concepts for car bodies has increased in recent years due to the necessity of weight reduction and improved crash safety. By using hot stamping or also known as press hardening of boron alloyed heat-treatable steels, it is possible to produce parts with a much higher strength than by cold forming processes. Depending on the stress profile of a structural part, it might be desirable to have different material rigidity in the part, with some high strength and other more ductile areas, so called "Tailored properties". There are a variety of methods to produce such parts, but all of these methods have currently still major challenges. Two methods to manufacture parts with tailored properties, these challenges and corresponding approaches are presented in this paper. This is on the one hand subsequently cooling in a spray field, which currently is still in the development phase because of challenges related to distortion. And on the other hand, the masked austenitization, which is used by only a few manufacturers due to the lack of experience, the impairments of coating condition and the great demands on the process management concerning re-cooling of the mask. Both variants are forward-looking and deliver high potential for further research.