首页> 外文会议>International Conference on IC Design Technology >Low phase noise K-band VCO and high efficiency E-band power amplifier for mobile network backhaul in SiGe BiCMOS
【24h】

Low phase noise K-band VCO and high efficiency E-band power amplifier for mobile network backhaul in SiGe BiCMOS

机译:SiGe BiCMOS中用于移动网络回程的低相位噪声K波段VCO和高效E波段功率放大器

获取原文

摘要

The mobile communication infrastructure is evolving toward small- and pico-cell networks, enabling higher channels capacity and user data-rate. This is motivating development of mmWave silicon transceivers for backhaul, and BiCMOS represents an optimal compromise between cost and performance. This paper proposes a Voltage Controlled Oscillator (VCO) and Power Amplifier (PA) suited for of E-band backhaul. Circuit topologies exploit the benefits of an advanced 55nm BiCMOS technology, fulfilling system requirements with low power consumption. The Class-C VCO features a state-of-the-art minimum phase noise of -119dBc/Hz at 1MHz offset from 20GHz with 55mW only. The PA is based on a common-base output stage leveraging current clamping to scale the DC current with Pout, keeping high power added efficiency (PAE) in back-off. Psat at 80GHz is 19dBm and OP1dB is 18dBm. The PAE at OP1dB and 6dB back-off is 22% and 8.5% respectively, at least ~2x higher than reported E-band silicon PA at comparable Pout.
机译:移动通信基础设施正在向小型和微微小区网络发展,从而实现了更高的信道容量和用户数据速率。这推动了mmWave硅收发器用于回程的开发,而BiCMOS代表了成本与性能之间的最佳折衷方案。本文提出了一种适用于E波段回程的压控振荡器(VCO)和功率放大器(PA)。电路拓扑利用先进的55nm BiCMOS技术的优势,以低功耗满足系统要求。 C类VCO的最新最小相位噪声为-119dBc / Hz,与20GHz的频率偏移为1MHz(仅55mW)。该PA基于共基输出级,利用电流钳位功能以Pout缩放直流电流,从而在后退时保持高功率附加效率(PAE)。 80GHz时的Psat为19dBm,OP1dB为18dBm。在OP1dB和6dB后退时的PAE分别为22%和8.5%,比报告的Eout的E波段硅PA高至少约2倍。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号