Efficient multi-keV x-ray sources from Ti-doped aerogel targets

摘要

We have measured the production of hv ≥ 4.5 keV x-rays from low-density Ti-doped aerogel targets at the OMEGA laser facility (University of Rochester). The targets were 2.2 mm long by 2 mm diameter beryllium cylinders filled with Ti-doped (3 atomic percent) SiO_2 foam. The doped-foam density was ≈ 3 mg/cc. Forty beams of the OMEGA laser (λ= 351 nm) illuminated the two cylindrical faces of the target with a total power that ranged from 7 to 14 TW. The laser interaction fully ionizes the target (n_e_(crit) ≤ 0.1), and allows the laser-bleaching wave to excite, supersonically, the high-Z emitter ions in the sample. The heating of the target was imaged with a gated (200 ps time resolution) x-ray framing camera filtered to observe > 4 keV. 2-D radiative-hydrodynamic calculations predict rapid and uniform heating over the whole target volume with minimal energy losses into hydrodynamic motion. An x-ray streak camera, also filtered to observe > 4 keV, was used to measure the rate of heat propagation in the target. Ti K-shell x-ray emission was spectrally resolved with a two-channel crystal spectrometer and also with a set of filtered aluminum x-ray diodes, both instruments provide absolute measurement of the multi-keV x-ray emission. Back-scattered laser energy is observed to be minimal. We find between 100 ― 400 J of output with 4.67 ≤ hv≤5.0 keV, predicted target performance is a factor of 2 ― 3 too low in this range.